Search results

Umm.....What kind of power was this guy putting into that shaft? I'm only intending to go to ~350-400hp when I install mine... PS- I've already bought a driveshaft loop for mine, so hopefully something like that won't be able to happen to me.... I hope....

Crap!- MODS- please move this to general section- didn't realize I was shopping when this question hit me!

Hey guys- I have read in a few different posts, that aftermarket single-piece driveshafts- particularly aluminum ones- tend to have a droning vibration to them. I figure that this makes sense, because it's basically a hollow metal pipe, and prolly transmits and amplifies the noises from the...

What he said. It struck me as strange that you had your gauge hooked to the FPR line instead of the manifold.

:werd: :withstupi :word8kn: You might have... that other kind of knock... And yes, you can use coax cable. I did on mine.

This advice is kinda in the opposite direction, but... have you checked your catalytic converter lately?? Mine was losing boost slowly; I couldn't build over 9 psi, and it was taking forever to build(5000rpm). When I got my cat replaced on this hunch, I found that the core was 80% blocked...

AMEN!- This happened to me- low CO, high NOX. The EGR should be removed, and you need to clean out the piping. I used carb cleaner, as well as a piece of braided metal wire in a drill chuck to roto-rooter the gunk in the small metal vacuum port tube, as well as the main metal exhaust bypass...

How long did it take you to pull the dash? It's something I need to do soon for the heater core replacement, and I just want to make sure I can pull it and replace it all in one day.

#1 God luck! Looks like you'll be getting into every aspect of a rebuild/restoration. #2 Replace all hoses, replace ALL bearings, all belts. Check your knock sensor wires while you have the harness out. #3 You can install the AFPR either before or efter the engine goes back in- it's...

Are you using your original clips? I don't see them- the square ones.

A recirc shouldn't have any more flutter than an atmospheric setup. You should be fine.

Did you ever check the ground wires under intake runner 5, like I asked? PS- make sure that you wiring harness doesn't touch the EGR valve- it'll cause a short.

Yeah, if you have a known leak, fix it and you should really feel the difference, if that IS the problem. I made exactly 260rwhp on a completely stock motor, with hardpipe kit, FMIC and exhaust, 7psi.

And do you still need this useful W58 driver's side bracket??

So...Do you still have that useless drivers side bracket? :naughty:

The wing brackets are different for a R154 tranny and W58 tranny, for the driver's side. If you need the W58 driver's side, LMK- I'll trade you for yours.

Does Barry Bonds drive a Supra?..... Is he starting a group buy? .................................... ....................no?............ Then who cares?

How the fuc& does an injector pop out??? It's simply not possible.

LMAO! The fact that you're holding a turbo and laughing at the Vettes isn't the funny part- What's funny is, that you DROVE to the Vette dealership, WITH your turbo, so that you could take a picture, laughing at Vettes! :rofl: :rofl: :rofl:

Cool story, and well written- but, if I understand correctly... you got home, then left the house, and started looking for this guy?