Search results

Dunno, but I moved mine lower by about 5mm.

Well, here's my ultimate plan: I want to go from a recirc DP which ends in a small flex section, from there to the cat, which will end in a 3pt flange. Then a nice quiet freeflow muffler which will be flanged on both ends so that I can take it out at my discretion. I can simply have a...

I was looking to quiet down my exhaust quite a bit, and was wondering what I should use. I have a 3"dp going into a 3" cat, and then back to a generic 3" N1 type can via 3" piping. Would placing a bullet style muffler inline after the cat give me a significant reduction in sound? Or, should I...

Glad to hear of the progress. Mine's been sitting, almost completely assembled, waiting for me to cough up the dough for a new clutch. My current engine is definately getting tired, though she drove a 600mile round trip yesterday with zero compaints, and the same trip 5 days earlier as well...

And bring the rods too!

Buy a beater for $800, spend the rest on a new engine setup (rebuild kit), and when you're done, sell the beater and buy a nice exhaustintake combo or something.

Would look ok if the entire interior was in suede like that. On our cars, it would certainly look good if it was in leather w/ leather interior.

Moving timing from 0 btc to 10 btc should make a huge difference to your initial responsiveness.

Hold the rpm at 2500 by hand. Is there a rattly sound there?

Same same. :biglaugh:

No, but replacement Supra parts do.... Actually, I felt the same way: "glass-pack" = "red-neck". But honestly, I'd really like to hear a sound clip. My exhaust right now is louder than I'd like; it's a separated 3" downpipe going to a 3" cat and mandrel bent piping to an N1 generic out...

You have some very good questions there. As far as the brake fluid getting dirty so quickly, it may be a symptom of a leak in your system, or if not a leak, a contamination by some worn components, like rusting caliper pistons, or rusting lines(water contamination on the inside). Flushing the...

It was a 3.91, but it's pretty old now... :biglaugh: kidding. That was an error. I meant 3.91

I don't consider a Taco Bell meal to be a waste.

Get the Goodridge from CK- It's a better name brand than what I got.

122 when i was na

Got mine for $60. (3.89)

Isn't the cold start injector on the underside of the intake manifold? I used this item from Summit: http://store.summitracing.com/partdetail.asp?autofilter=1&part=PRF%2D30110&N=700+1003+115&autoview=sku It's 3/8 npt, but it screwed right into my Tstat housing, no leaks, no problems.

I remember that sound. I had it too. Turned out to be the throttle body gasket. Replace that. Do it. Just DO IT.

I once went 57 in a 55...