Search results

  1. I

    Are you a certified welder?

    A certified WELDER A certified WELDOR (just messin with ya either is acceptable)
  2. I

    Ever found a Canadian quarter in your change

    Just charge 25c entry fee that'll stop em at the border ;)
  3. I

    JT2MA71's Build. Dyno video on post # 1191

    :cry: damn......
  4. I

    Will a bad turbo still make boost?

    Sluggo: Pull the accordian hose off and wiggle the shaft and tell us if there's play in it please.
  5. I

    What the sh!t is this?

    Full stealth ;)
  6. I

    Cut Springs?

    You need to drive something with properly sorted matched suspension so you can see the difference ;)
  7. I

    Turbo manifold thoughts.

    Ran my SSAC with an open 3540r and it was fine Fredde. (you'll need a spacer so the Comp cover doesn't his the runners)
  8. I

    to ceramic coat or not....

    You're such a high tech baller Joe :)
  9. I

    How much torque should I torque a 2mm HKS headgasket?

    No oil for the bottom end WD40 instead ;)
  10. I

    How much torque should I torque a 2mm HKS headgasket?

    No head bolts use Duct tape ;)
  11. I

    to ceramic coat or not....

    Cletus :D
  12. I

    garrett gt4082 users

    Logan: Yes it all has to work as a system. The last vid was with a LOT of changes to make the power delivery Softer and to kill off as much low to mid range Tq as I could. (very short runners on the FFIM and large plenum volume) The new motor is built to get ALL of this back and more and...
  13. I

    What the sh!t is this?

    My old PWR setup.
  14. I

    What the sh!t is this?

    A pump ;) <dejavu post> Dats: Not so if you run a full 2nd cooling system for it. (I used to run PWR W2A IC's)
  15. I

    Who all has a beater for the mileage?

    SS5k: Pics of the Mighty Metro? ;)
  16. I

    Cut Springs?

    I see everything ;) <Sgt Shultz voice>
  17. I

    garrett gt4082 users

    Might consider a lower diff ratio William.
  18. I

    to ceramic coat or not....

    A sandblaster loaded with Aluminium Oxide ;)
  19. I

    garrett gt4082 users

    William: Done just that now with the T04z on my motor, my "guess" would be Spool remains around the same with less backpressure/choke at high engine speeds. gt3540r 1.06 ar T04z .84 ar We'll see soon ;)
  20. I

    Cut Springs?

    Bingo! Good post Johny welcome to SM! :) (not to mention the dampers WILL be mismatched for the new spring rate from the cut springs)
Top Bottom