Search results

and the relay is attached to the antenna

those battery terminals aren't that good... I know from experience, they look good, but they don't work for crap.

Take care of em ;) Vinyl wears faster in my experience, real leather is used for motorcycle gear because of it's abrasion resistance.

considering I think the factory original ones where real leather...

Know what works good on cast iron manifolds? Graphite spray lubricant. After the solution burns off, all that's left is the graphite leaving it black and clean. You can't really handle it after that, but touchups are easy...

Most people won't notice the difference, but there is one crutial one. Leather if it gets wet doesn't really get slick, while vinyl does. Leather shiftknob and steering wheel wrap kicks ass because of this.

Unbolt from the diff, and unbolt the center bearing, and let it hang down. Don't slide the yoke out of the tranny or you might lose fluid (mine didn't, but I used a yoke from another driveshaft to plug the hole when needed)

Most of those suck as they don't get a good connection. Someone had butchered mine, so I got a set of the pre-made ones that aren't very long, got the copper bolt down connector pieces and melted solder in em with a torch, then stuck the cable on the car in them. Bolted the ends of those...

no, and like already said, it won't really matter much since the rotor is so small.

A screwup here will cost you the motor... If the oil pump drive siezes, the engine starves of oil and it's goodbye motor...

yep, plug and play

Yes, but having a backup is nice. Also keep in mind that toyota overbuilds their stuff a lot...

Personally I wouldn't cut up the old axle to put the other one in, I'd either find a way to beef up that axle, or find a better solution that might bolt in... I'm sure someone can find a MKI axle...

nah, I think you're just hearing things since you're old...

yep, alternator fuse would do it for the most part...

It's going back to base maps. The ECU can compensate when things aren't ideal (like if the car isn't in the ideal environment, or some stuff is out of spec), but when it goes back to base it has to relearn. It's normal...

Man, that red wire would bug me.. LOL

Is that oil pump drive from that engine? If not, it more than likely won't fit, it will have to be resized for the bearings...

You can't just say that and not tell us WTF it was...

I95 in Florida is straight as an arrow and flat as a board.... If there is anywhere in the states that you can hit those speeds it would be there...