Search results

STOP RIGHT THERE!!! AN is always, 100% ID (Inned Diameter) not OD (outer Diameter) Because you are lookng for automotive only. Look at hydraulic shops. They carry -05 AN hose AND fittings ;) with that said.... what mkiiiman said, which is it? ID or OD?? It is without a doubt, ID. AN...

there is no relation. medium frame as done by garret is the install base. A t4. Large frame are the T6 turbo. The Garrett Large frames don't start until the GT45's though.

edit 9/9/09 fixed the AEM link to point to the AEM V2 Fixed the Big stuff link as it was giving a 404 not found. added the Link ECU (close cousin of the Vi-Pec) Added the Tag Mclaren EMS link Fixed the Pectel as Pi Research is now Cosworth. Yes the cosworth of the ford racing familiy in...

Agreed. bought my 87 with 42k miles on the clock back in 94 (i was 2n owner). Went from South Dakota to Miami in 96. Daily Drove it from 96 - 98 then moved to Minnesota. Daily drove it from 98-04. Through rain, snow etc. Never once did it "break". And at one point I even upgraded the turbo...

Hmmm debating whether.... On second thought. Dead thread. Vague questions get you no where.

umm did you ask him/them that you want to know so you can make your own? If so, no wonder he is reluctant.

if he won't tell you. Then he has something to hide so RUN AWAY AS FAST AS YOU CAN! guess: Brembo or Rotora blanks since they are not two piece.

hmm check the Authorized vendor section? http://www.supramania.com/forums/forumdisplay.php?f=6 /closed

if they are 14.5 ohms 1/(1/14.5 + 1/14.5) = 7.25ohms if they are 15.5 ohms 1/(1/15.5 + 1/15.5) = 7.75 ohms did Aaron test you stinger out to make sure the injector channels are not fried? The harness that Aaron built. Did he wire them for full sequential or is it using the stock...

Bri7man I need numbers (just like the TSRM needs numbers). I know the stock guage does not have numbers that low and it is usually a wise idea to use a 15 psi gauge for idle check as you really need the resolution.

Ok jus tso we are clear. Are you 100% sure that it is not 4.3? Accuracy of the guage?

did you use the TSRM? http://www.cygnusx1.net/Supra/Library/TSRM/MK3/manual.aspx?Section=LU&P=4

SS lines should ALWAYS be pressure tested whether using the resuasable ends or the crimped fittings.

Besides some of us that are always looking for hard data, who would have such precise measurements? Toyota perhaps but they are not giving that away.

well well well speaking of Kingdom Hearts http://www.square-enix.co.jp/kingdom/bbs/ Guess the prequel is starting to look almost complete! :D Ventus looks alot like Roxas (Sora's nobody). I mean identical! Father perhaps? Terra (Zack from FFVII) is the BA. Trying to figure who Aqua is...

I agree. The introduction of the nobodies and the drive forms made the 2nd part leaps and bounds better from a combat perspective.

PSST Mickey wields a wicked Keyblade and if given the dual blades + allowed to go into final form....... ;)

go to another store... Print this out to incase they give you lip. taken from http://consumerist.com/5183468/

No problems found as in how long did the pressure hold time wise? If there is no pressure loss at all. AFM electronics are screwy.

I never got around to measure the 7m ignitor assembly.