Search results

Looks like i was wrong, i used my pushing jig to get the bushings out and I placed a wood ruler above the rear bushing hole top surface on the subframe, and insert the caliper tail from the bottom, indeed the rear is also 65mm, NOT 58mm as I said earlier, I had difficulty measuring that area...

I am in the midst of installing the rear RonnieK subframe bushings and found something odd. The thickness of the rear 2 bushing mounts vs the 4 front bushing mounts are very different. The front 4 and the rear 2 If the subframe thickness is not the same , why are all the 6 bushings the same...

Hi guys, I wanna make some urethane pads/bushings for the front subrame, and I need the upper lip part dimensions as shown in the diagram below, if some one has a subframe out please measure them in mm and share it. The drawings I made I will share here. Thanks

I placed the toyota jack with a piece of wood to support the front of the sump. when re installing the steering rack i needed to support the rear of the sump and remove the front sump jack otherwise it was blocking the rack. I say leave the engine in.

I made the mistake of allowing the subframe to go down all the way to the floor. I should have placed something underneath the subframe to keep it lifted a few inches of the ground, that would help tremendously with sliding my standard jacks underneath to lift the subframe up when installing. ...

Hi guys. I am swapping out my stock subframe bushings that has hardened and sagged with a set of Ronnie K softest bushings. Right now I am facing an issue where the only one original rubber top hat is making contact with the subframe "lip" but the rest of the 3 rubber top hat is not touching the...

I am so glad the site is back. I notice that the data is up to 2018, will the newer posts up to the crash come back too ?