Search results

  1. I

    Unleashing The Beast... (56K Beware!)

    turn right more ;)
  2. I

    Auto Upgrades Needed When?

    BIGGEST cooler you can fit from day #1.
  3. I

    Billy Mays dead @ 50... celebrity spaceship taking off?

    Tried it a couple of times didn't much like it so think I'll put it off a bit longer ;)
  4. I

    FINALLY - Especially for JMDigital - LilMissMkIII's Build

    Chloe chucking up on the Soarer :D (What made it funnier her dad was holding her and it was his car)
  5. I

    FINALLY - Especially for JMDigital - LilMissMkIII's Build

    I witnessed it and can confirm it as fact ;)
  6. I

    Antisurge/Ported Shrouds

    My 04z surged like a bitch till I tweaked the BoV's. Before the tweaks mine sounded like "Powered By 3Stooges" if I was on/off the throttle over 15psi.
  7. I

    FINALLY - Especially for JMDigital - LilMissMkIII's Build

    I could fix that :evil2:
  8. I

    FINALLY - Especially for JMDigital - LilMissMkIII's Build

    I'll leave it for Kristel to explain what form the criticsm took :D <snap>
  9. I

    Alignment post Eibach and Illumina 2's

    Very welcome Mark I ran into this on my car when I dropped it so it's not guessing ;)
  10. I

    FINALLY - Especially for JMDigital - LilMissMkIII's Build

    She's a critic of Soarers though :biglaugh:
  11. I

    Alignment post Eibach and Illumina 2's

    Should still be within the adjusters range then Mark! Front can be slammed and still be aligned to spec the rear once you go 1.5" down or more you plain run out and need to shorten the lower transverse arms.
  12. I

    Alignment post Eibach and Illumina 2's

    How low did you go Mark?
  13. I

    Billy Mays dead @ 50... celebrity spaceship taking off?

    NOOOOOOOOOooooooooooooooooo.................................
  14. I

    Billy Mays dead @ 50... celebrity spaceship taking off?

    shhh it isn't...
  15. I

    Clutch release issue.

    Pete: Repco stock the Mity Vac pump and a one man bleed bottle I use it for any bleeding work as pumping the pedal tends to aerate the fluid.
  16. I

    Clutch release issue.

    Why would I bother and risk the paint when I have a single person vacuum bleeder?
  17. I

    Clutch release issue.

    If the step is machined correctly on the flywheel you shouldn't need custom parts Pete.... I always had good luck vacuum bleeding mine could never get all the air out pumping the pedal.
  18. I

    VPC map sensor 2bar?

    It will just stop adjusting anything once over it's maximum rated PSI Brent, most times you're rich enough up there not to have any issues.
  19. I

    what is the best thing to use to seal my oilpan?

    same shit different bucket ;) YamaBond HondaBond and so on we seeing a pattern? It's very popular amongst the Japanese companies.
  20. I

    what is the best thing to use to seal my oilpan?

    3bond 1207b>everything else I've tried.
Top Bottom