Search results

Everyone is running lean and I am running rich. Jeeez.

The fitting to the block should be snug, it seals with a copper washer. Be careful, those threads are easily stripped. The -AN fittings should be right as they seal with a flared end like Hvyman, that goes into a counter sink. Just make Sure it is tight. Hold the fitting with a wrench after...

Well I know it can't be the Koyo, maybe CXRacing or another off brand?

TPS could be bad. Check the continuity back to the computer too make sure the wires are good. If they are, the TPS is bad. When I get a TPS code, it is usually 51 meaning it is not adjusted properly. Did you check to make sure the idle up screw, if you have an early throttle body, is not...

I have used a Koyo aluminum radiator with my car and a stock 7M fan setup with no clearance issues.

Nice find. Keep this thread posted.

Let's go through your post and tell you all the wrong and right information you have learned. Stock fan dangerous with a shroud? You are right, it can break fingers and other body parts if they should come in contact with it. The Fan Clutch Robs Power? This is wrong. It barely robs any...

Make sure to show pictures of the catch can when you get it. Recommend it to your buddies to. ;)

I have been looking for a 4Runner for out winters here in NY and I can't find one with a 22R in it. Dumb V6. I also second Steve on the timing chain guides.

And it will make your girlfriend's vagina less sweaty thus keeping unwanted odors away. :D

Get back on your feet financially, put the car in the back seat.

A/C = Air Conditioner This system utilizes freon, a gas, that will flow through a set of pipes and goes through a condenser for cooling, dryer and an evaporator. A belt driven compressor spins a pulley which turns a clutch that circulates the freon in the system. The clutch is engaged when...

Whoops, good catch, I didn't even look there, just where he was pointing. Don't grind off anything, just do what hvyman said, put some oil on the cam and journals, install them and turn slowly while watching the tab. Also, make sure tue prop up the head to clear all of the valves or you could...

I don't believe so but is that right where the cam sensors go? If so, those are the tabs for the cam sensors to read to know the location of the valves. It is like the trigger wheel for the crank sensor but just a tab in this case. Contact BigZavs on here, he know about that since he had his...

Nice. I am happy that our shop has one. Just set time to evacuate, amount of gas to charge and leave it alone, well until I have to start the car.

I changed the two o rings on the compressor lines and I will put some dye in the system to show any leaks. Dustin, you have an A/C machine?

You still get R-12? Where? I hope my A/C works. Previous owner said it did but leaked, so I hope it just has a leak.