Search results

Ok, Im going to give you all a Exact Spot where the oil seems to be coming from. Look at the Head and where the Plate meet on the Passenger side. If you see where the Plate Dips in under the head a little, I have about a 11/2" wide trail of oil leaking from there. Directly under the...

Would it leak from the Area that I Discribed if its the CPS o-ring. If so, I have a Kit of O-rings that I can Replace it with. Robert

Yes, That is exactly where its coming from. Its not alot but enough to make it run down the block and some of it is going into the Lower timing Belt cover. Its like the oil is Splititng the Edge of the lower timing plate, Half inside it and the other half is running down the edge of the Water...

Hey all, Just need to know if I have a Blow HG. Im getting oil leaking between the Block and the Head right under the Exhaust side cam Gears. You can see where is is coming from, I thought that it might be the Cam Seal so I replaced them, Any Suggestions or do I just need to retorque...

Well, I have a Pretty long list of Mods. I think he said that this was Pretty much stock. He wants to Upgrade to a Turbo but not for sure how long or when he is Planning it. Robert

Im not for sure what the HP rating is in a 97 MK4 non-turbo but from the looks of it, It cant be too much. Was out that the Track last night and a MK4 showed up. First timer, So about an Hour before the Place shut down he came over and started looking over my car. After a little talk he asked if...

Nope, I originally put the Oil Gasket back in it Until I got the New ones in. I might have tightened the gasket too much. Im going to see if that is the case. I bought an Extra Flange gasket anyways. Jon Does Excellent work and I dont think it has anything to do with the Rebuild. Just...

Turbo XS RFL, Im not running a Accordian pipe either so there is nothing Interfering with the Turbo Inlet. Just a little confused on why Its still leaking from the Exact same Place with all New Gaskets, oil lines and all. Robert

Hey all, Well I figured I would ask you all in here since there are a few that know about this Issue. I recently get my Turbo back from getting rebuilt and ofcourse got in installed into the car. What I have noticed is that Im getting a leak from where that Oil feed and return line mounts to the...

Ok, Since we are talking about Jon and his ability to Provide a Excellent Product. I had a 57 Trim CT26 that I sent over to him to get rebuilt. Now when this turbo was sent, It only would spin about 2/3rds of a Turn before it stopped and The Side to Side play was so bad that When under Boost, It...

Well, I can say after going out today and resetting everything that its looking like a wastegate Issue. I reset the Boost Controller and did the Inital setup. Odcourse, I only got 7 psi for low and High boost Setting. Now after setting up the Hight boost, I started as I would be at the Strip...

Ok all, Here is something that I cant figure out and Its making me think about selling.... Right now, I have a 57 Trim CT26, RC 550s, Lexus AFM, Megan Racing AFPR, MKIV Fuel Pump, SAFC, Wideband with a HKS FCD. If Im out just doing my daily driving around and i boost in any gear, I can...

Hey all, Just wanted to say thanks for the Help. I got it installed and It says run it at Idle for 5 Minutes to let the SAFC Set itself to the Vehicle conditions.... Ok, I did that. What I noticed is that the more I let it set, the farther towards Rich the Wideband went. Right now, Its all...

Makes sence.... Here is my Delima. I looked at the wiring Diagram for a 88 Supra turbo and on the 24 Pin connector, I have a (KS) and a (VC) wire and the Diagram says both of them are Air Flow Meter Wires. Which one do I connect into. The SAFC wiring Diagrams Points to the Bottom Wire which...

Hey all. Someone Please help me here. Im installing my SAFC and When Im reading the wiring Diagrams, It tells me to Connect the following Pink wire to the Air Flow Signal Output wire Orange wire to the Air Flow Signal Input wire Im looking at the ECU wiring Diagram and It doesnt tell...

Hey all, I recently upgraded my Injectors to RC 550cc and installed a Lexus AFM. once I started the car up, I noticed that Im getting a slight miss sometimes and It Idles a little rough. Do I need to Increase fuel pressure or what. First time Unstalling new Injectors so Im a Little curious on...

I Agree, I agree.... Hell Im going and I only own a MK2. But what the hell. I wanna have some fun too. Robert

Hey all, Just wondering here. When you First build a 7mgte Engine and you do the break-in time, Do you have or do you need to go in and recheck the valve shim clearances. Reason Im asking is that Ive started to Notice that my car is starting to clatter a good bit at around 1800rpms if I...

I Agree with the No start there. We have been looking over this engine for quite some time. Everything to do with the Electrical Aspect to Replacing Items that we know now didnt need to be replaced. I called the Builder up today and told him the Problem. He couldnt believe that he was that...

What are the Tolerance Measurements. Im going to check mine this weekend and correct my Friends motor that the Builder installed His Cams backwards. Basically, Intake cam is on the Exhaust side and Exhaust is on the Intake side. Couldnt believe it myself and he have been trying to get this...