Search results

You will find most here will say "storck" fans work better - flow more and fewer problems. If you search it you will find have been many debates over this subject here.

Get one of these: http://www.harborfreight.com/automotive-motorcycle/brakes/brake-bleeder-and-vacuum-pump-kit-92474.html Works well and you can do it alone.

That is capped off correctly and not used---

This is a Toyota only item - I have never seen a post where they have been found at other sources. I need to replace my own so I will bite the $$ bullet. Also I want to get them while they are still available I suggest you do the same.

Yes, Here you go. http://www.turboninjas.com/mk3supra/ The 87 is TEWD is in the fist section and is about 20MB. It is the UK version but should work for you.

87 Turbo 186000 miles all original including head gasket. Head gasket did give up at the 186000 mile mark (engine down for rebuild).

Yes, blades will have that look under the PAINT. I am doing mine now. They are turned on a lathe when manufactured and are very shiney under the paint but no powder coating which was not used 25 yrs ago.

Remove the passenger side lock - look on the side of the cylinder, there will be a code (one letter followed by 4 numbers). Take this code to the dealer. They can punch a new key for you in less then 5 mins. Cost: about $7 (for the key blank).

This is the plug your looking for :

Found this on my computer (orig. from Supra Central). Dash removal 21 Steps Procedure: 1. Remove 2 rear center console screws 2. Move driver's seat *all* the way back and raise windows 3. Disconnect neg. battery cable 4. Remove ashtray, driver's foot cover with the...

Harbor Freight offers two models. One is a Two Ton the other is a One ton. The One ton version looks very simmilar but does have a "shorter boom arm" Which do you have?

"IF" the valve stem is stil in the guide you can reach the end of the valve head THRU the spark plug hole - not thru the valve guide hole---

I am an current owner - 87 Targa GTE Supra. Currently in Lawrenceville near Gwinett Mall however, soon to move to Buford.

Aggreed, a length of (coat hanger) wire bent with a small hook on the end thru the spark plug hole you could work it back up into place -----

Did the valve fall all the way in and is loose in the cyl.? If it did the head must come off.

Yup, it only comes with a new harness. I replaced mine with 5/8" plastic wire armour. The type that is corragated tube and split along its length and then wraped it with electrical tape. Fit in the same place-----

No, only the turbo--

I believe you can use the auto with a manual but not the manual with the auto. So you should be OK. Some leads are different neutral switch etc. Some of the other guys here could give you more detail perhaps.

You can still get them from Toyota. The part # is 67881-14110 (called weatherstrip-backdoor. They are going for around $70-$75. It even comes with glue in the notch so all you do is press it on.

The cygnusx1.net site is a great refrence tool for these cars. "]http://www.cygnusx1.net/Supra/Library/EPC/291210/catalog.aspx?F=5102&P=1"][/URL][/URL]