Search results

updates, would you guys think its a bad radiator cap? the coolant in the overflow bottle goes to the hot level but when the engine gets cold it only returns a little bit of the fluid back into the radiator, i also noticed, i installed a tee-connector by the heater valve where i usually would...

i may have not seen your car in person before, but im leaning towards having the black flushmount housings, they look clean!

compression readings were high (didnt take notes of the PSI) but they were high all i know lol, coolant system maintained 11psi pressure on the pressure tester, coolant noise seems to have decreased like theres only small bubbles in there now, will check level tomorrow and top off if needed, im...

but why is it when i am at a stop light and the temp is on 85 on the climate control you would hear the servo door in the dash moving like the sound when u change the temp? im not pressing any buttons but it does it by itself..

replaced all heater hoses with new ones, 90 degree bend hoses are new as well, rad hoses are new and clamps are new as well, head gasket is torqued to 85ft lbs, heater valve bypassed, rad is new, cap and thermostat is new, no apparent leaks anywhere, no fogging up windshield inside, where could...

Car is improving more and more everyday i see it Adam! i need to work on getting a 2jz in mine or at least a 7M-GTE :)

Before you guys go off on me, i would like you guys to know that i have already bypassed the heater control valve in the engine compartment, coolant is full but i notice at times even at 84 degrees on the climate control, the heater would just randomly blow cold air like its at 65. I would come...

updates, no visible leak has been found but i did notice the water level always dropped after an hour or so, im hoping its not the heater core, not head gasket as the exhaust does not smell like coolant, nor did the cooling system have exhaust gases, i did notice the hose under the dizzy was...

heres mine at a local park (still in need of that door molding)...

alright i will check the 90 degree hose on the back of the engine bay as well as the metal hose that wraps around the engine block its just weird how i dont see smell or hear anything and i dont see moisture in the car so no way its the heater core. Ive ran full water on other cars before they...

As for NTRA08's post, I am running coolant in the system, but i believe since the leak was repaired i have been using more water in the mixture than coolant (3 h20 to 1 coolant) could that be causing the issue? I have a new OEM thermostat already and cut the jiggle valve off. It just seems to be...

Okay so i pinpointed my radiator to be causing the loss of water, and so i replaced it, it HELPED, then i got a new thermostat and rad cap, i topped the coolant off, drove it around no coolant gushing noise, on the way back home, LOTS of coolant gushing noise. Did the same next day topped off...

might be an old post but your clutch pushrod freeplay and pedal freeplay need to be adjusted according to the TSRM specs: http://www.cygnusx1.net/Supra/Library/TSRM/MK3/manual.aspx?S=CL&P=3

while i have no better wheel, i grabbed a mint toyota wheel from a parts car for super cheap i couldnt resist, a new wheel later on but got priorities first, im lovin this wheel compared to my torn supra one :D

gallon of water, flashlight, booster cable, screwdriver with assorted bits, emergency flares, reflectors, tire inflator hole sealer thingy basically everything in a roadside assistance kit to be sure

check your fuses as well as any unplugged connectors

are you w58 or r154, my w58 harness to get reverse ;lights to work look like this hope it helps..

heres mine:

W58: has the bell housing without inspection covers the clutch slave pushrod and clutch fork is outside the transmission front half of the driveshaft (goes into transmission) is one size unlike the r154 R154: bulkier transmission than the W58 clutch fork and slave pushrod is located within the...

awesome build!! im loving it!! :D