Like the title says does the air conditioning lines from the turbo 7m work on the 2jzgte.
Also does it route the same way in the engine bay?
Thanks in advance. ITS SO HOTT OUTSIDE
So let me know guys what dual fan setup you guys have good luck with..i would really like a high CFM
---------- Post added at 11:15 PM ---------- Previous post was at 11:13 PM ----------
Going on Aristo 2j mk3. all aluminum radiator
I have an aristo 2jz and it doesn't appear to be running hot bit it keeps filling the coolant catch can and then pooring it out the top while im driving! I noticed today that the needle was slightly higher but not over heating! And then when I finally come to a stop the flow.starts to increase...
Ok im asking for my friend. He just did a Na to a turbo swap. It was having problems boosting so he though it was the wiring job that he had going on so he bougt another complete harness and Ecu. And now car once you give it about a quarter throttle it stops accelerating.
Code 51 and 22 are...
OK I've been searching all day and can't find any concrete answer on how to rout the harness of the 2j from a aristo in a mk3. I really don't want to extend the harness. So where is the best place to drill in the firwall for the haness to go thgrough. I heard of some people driling behind the...
OK I'm getting near done with swap and I need to someway come up with a downpipe.
Its a aristo 2jzgte I'm keeping the stock twins. These are the options that I have come up with.
(1) First would the aristo stock down pipe work with a little modification.
(2) or take a mk4 down pipe and cut off...
Hey I was just wondering if anyone here was going. It be nice to see some fellow suora guys out there.
Hopefully will have my 2j swapped mk3 done before then.
Here's the Facebook event page...
http://www.facebook.com/event.php?eid=179670932062278&ref=ts
Im putting a 2JZGTE Aristo Motor in my 1990 MK3. What should i do about a down pipe.
Is there any stock down pipe i can use or should i just have one made.
thanks keith
I was wondering how i need to run the belt with no hydro fan pump. Or do i need to get a new belt all togther and of so what size. Part number would be really helpful!
http://www.titanmotorsports.com/sutatopsc.html
Hey i Saw these screws on Titan Motorsports for the targa top. There listed under the 93-98 supra. I was wonder if anyone knew if the screws are the Same. I Would like to order them just need to make sure they fit!
Thanks in Advance!
I have a 1990 MK3 and im swapping in a 2JZ
(1) My question is can i use the Clutch and Flywheel from the stock MK3?
(2) Are the 1JZ and 2JZ Flywheel the same?
Hey i have the aem tru boost controller and i have read the instructions and watched videos and tried guessing but i can not figure out how to use this thing..i have no idea what duty cycles are and what percent to put it out..
If someone could call me i would be very thankful...
dont know if this is a repost or not but this is awsome..the launch is the best part
http://www.streetfire.net/video/Celica-2jz-652216MPH-time_687963.htm
Too bad i know this guy..didnt know he was making fun of the type of car i drive on another forum :: angry ::
http://streetcarforums.com/showthread.php?t=165301
Dont know if anyone has seen the is yet
Heres the link to the Article
http://www.autoblog.com/2010/01/29/report-toyota-gs-performance-division-in-the-works/
First off i have done my research and i am more confused than i was before...
http://www.supramania.com/forums/showthread.php?108723-Power-steering-1jz-swap&highlight=power+steering
http://www.supramania.com/forums/showthread.php?63631-My-1JZ-Swap!&p=933571#post933571...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.