Search results

I have an act stage 3 six puck on a new rebuild engin.Stock flywheel resurfaced. It also shudders when I take off from a stop in forward or reverse. It is more than a chatter. I have only a couple of miles on the clutch( like 2 or 3). I agree that looking thru the inspections opening would be...

congradulations! I know the feeling

Since the car runs, I need to make sure it can stop. i am trying to get the rotors off, the fronts were not a problem, the rears however.... I was able to remove the bolt that holds the caliper to the torque plate. On the drivers side the caliper was frozen in place, I can now move it up and...

thanks for the info- wanted to make sure something was not going wrong with the clutch- I sure I will have many more questions as I get this thing up an running, I do appreciate everyone's help!!

Luis 240-508-1449 www.paradiseracing.com

Thanks for the responses- While you were breaking the clutch in, did the car shutter? My car shakes then starts to move. If I rev it to like 1500-2000 then slip it, it will engage much smother, but at like 1200 the damm thing shakes.

Checked all the grounds again checked the connectors at the ecu fully charged the battery reseated all the fuses problem gone- car goes to 3500 no errors- boost started to build!! great feeling. I am sure there are lots of problems lurking around on a car that has now sat around for...

As part of my rebuild I replaced the clutch, resurfaced the stock flywheel and replaced the slave clyinder. with less than 1 mile on it, when I engage the clutch the car shudders then starts to move. Wondering if this is normal? How do you break in a clutch? the clutch engages about 3/4...

you mean the steering rack?? Its a PIA- but not hard the outer tie rods the power steering lines ( hard to get to) 4 large bolts, 2 on each side. the bolts go to half circle pieces that clamp the rack in place. The TSRM has some good pictures. However, check the steering linkage fromthe...

Sorry to hear about the bad luck... Where in NJ are you? Steve

Thanks guys! Changed the Oill this morning, charged up the baqttery, added some air to the tires. took it out for a quick little spin around the block ( no plates etc) The smoke seems to have cleared up, but when I step on it a bit, over 2500 rpm the check engine light comes on. When I pull...

Well I have the car for almost 2 years- Bought it with a BHG. Replaced the gasket, and it still did not seal, that was year 1 then put it away for the winter last year i bought a long block and swapped engins- after starting it up, lots of white smoke. Pulled the head off and found out the...

front trans seal http://www.cygnusx1.net/supra/library/TSRM/mt/MT_72.html rear seal http://www.cygnusx1.net/supra/library/TSRM/mt/MT_73.html

something like these? http://www.suprasport.com/product.asp?itemid=144&catid=67

checking in- feels like the same place with a fresh coat of paint!!