Search results

Thank you very much!

I picked this kit up from Aaron and unfortunately crushed a portion of the line, in tale causing a leak. http://store.driftmotion.com/static/i-7mfueldampenerbypasshose.php Does anyone know the AN fittings on the line, unfortunately i dont have access to my car but have some downtime to get...

Hey guys, Just wanted to confirm which is outlet(to filter) and which is inlet(from oil cooler) Cheers! http://i257.photobucket.com/albums/hh211/xTeamclassic/photo.jpg?t=1329932915 Another question while im at it, anyone have a a close up photos of the pcv piping coming off the...

Thanks brother!

Thanks for the fantastic responses! much appreciated problem solved

Can anyone confirm where the line goes from the powersteering pump?

I got that, i was just to confirm exactly what the line looks like and how it's attached the the water outlet housing..

Hey guys, Was wondering if anyone has a photo laying around of these lines? http://www.cygnusx1.net/Media/Supra/Library/EPC/Figures/MA9047B.gif From the turbo to the block, and the turbo to the thermostat housing. any help is much appreciated!

Hey guys, This is my first overhaul i've done, just have a couple quicks questions, any pointers greatly appreciated! Whats the difference between grey plug vs yellow plug engine wiring? I'm reusing a hks mhg, going to remove all existing viton and apply copper spray, but how exactly do i...

Hey guys, i just picked up a mint jdm 7mgte, but the buyer before had the intention of building the motor and mid-way through gave up on the project. Nonetheless the motor was mostly together besides the removal of the oil pan. Now the motor was covered up but had sat in a shop for a couple...

Hey , I'm re-torquing my headgasket today (arp studs/metal headgasket) was wondering what sequence i should go abouts doing it . Thankss , much appreciated

Hey guys, i just want to confirm exactly which wires go where . having trouble finding any information online! thanks alot! ---------- Post added at 07:32 PM ---------- Previous post was at 07:29 PM ---------- I currently have it setup as : black - EQ1 power ground red - +B EFI main relay...

Thanks for the response , I will try that most definately . But I thought 5ms were high pressure low volume and 7ms were high volume low pressure , will that have anything to do with the sensor ?

Heyy, Just swapped a 7mgte into a x73 Cressida , oil light is always on ; there is pressure . I'm using a 5m oil pan and pump . Any solution to this problem , I also do not have my oil cooler hooked up .

How should i run it than? How can i tell whats in / out? ---------- Post added at 07:25 PM ---------- Previous post was at 07:24 PM ---------- Thanks btw

Should i run my fuel pressure line as followed -> TB , VSV than FPR ? I don't have my car in front of me but is it basic to determine what is in / out for the VSV's?

Heyyy , Just wanted some advice on how to run my EGR , i'm missing the piece listed below and im having difficulty deciding how to route my lines as its rather difficult to determine where each line is going from the piece im missing. http://oldschool.supracentral.com/repair/vac-hose2.gif...

O ok, i have a cressida with a 7mgte and found this in a box of goodies . Thanks for the confirmation!

Hey guys, Does anyone have a schematic or diagram as to where the turbo pressure sensor assembly is located, harness and vacuum line. little stumped, any help is appreciated

Another question i was meaning to ask, where is the vacuum line running off the rear of the manifold supposed to go?