Recent content by Supra mn

Tried messaging you back, but your inbox is full. Have a few questions for ya

Not sure what your other mods are, but if all you want is the extra 3 psi, why not just get a full turbo back exhaust and *optional* a boost controller? The 550 mod is just there to fool your ecu so you don't hit fuel cut. That doesn't happen until roughly 12 psi. The free flowing exhaust will...

In regards to this, I had the same problem running the rx7 injectors. People say it works without a problem.. I wasn't so lucky and it seems neither are you. However, it is an easy fix. Since the injectors are high impedence, and stock are low, you need to unplug the resistor pack, cut off the...

I love that after not even seeing my car for 2 years now, every car I drive leaves me dreaming to drive my Mk3. I had to buy an 87 junker temporarily just to get the feeling of a supra back. Buying that also convinced me that I'll be doing a 5 speed swap when I get my car back. I own a 92 SC300...

I don't have any experience with it, but I've heard of many members on here running the Tanabe Medallion exhaust. Stock looks, quiet exhaust but a nice tone when you get on it. I'm sure the members actually running it can give their input.

The lift is mobile, so the motor on the side does all the hydraulic lifting of the car; the pallet jack handle on the side would raise the whole lift assembly so you could move it wherever it's needed.

As clean as this car looks, i did notice a few things. Rear seats look to be faded/worn on the tops. Hard to tell by the angle. The car isn't as babied as you think: Look at the passenger side of the engine bay, there's a boost T hooked up. Not a huge deal, it's probably running higher than...

It looks like you are using the stock lug nuts.. From those pictures, your wheels are made for acorn-type lug nuts, and the stock ones are the flat, washer-type lugnuts. In other words, if you're using the stock lug nuts, you need to buy new ones that are correct for the wheel; before you lose...

http://www.cygnusx1.net/Supra/Library/TSRM/MK3/manual.aspx?Section=EM&P=4 I have the rx-7 550cc injectors as well. You can't just unplug the resistor pack, you have to solder the 4 wires on the harness side that plug into the resistor pack. Or do what I did and find a plug from the junkyard to...

I have 17x9 +24 up front and they sit about perfectly. If I was another inch lower they would start to rub the fender, but on just lowering springs I'm fine. Rears I have 18x10 +30 and the tired tuck right inside the fender, lip pretty much even with the fender. I haven't rolled/pulled anything...

I've heard a lot of bad things about those universal antennas, and since the supra already has a built in antenna in the back window, why put a second one there when you can just make the one in the window the primary? http://www.amazon.com/Dynex-Antenna-Adapter-Cable-DX-A1122/dp/B001RENI2A $3...

Surprisingly I only took a few pictures after I installed mine, and if I don't have access to my car any time soon. Basically I have 90* couplers off the intercooler connecting the pipes. The piping kit is the DM intercooler kit, with only one slight modification to the pipe inside the fender...

You took the silencer out of the tailpipe right? I love my DM exhaust, somewhat quiet at idle yet still sounds mean, and loud as hell when you go WOT. Sounds amazing. If you think that's quiet, just go open downpipe..

I bought my 89 white package, all original, second owner, had it since '90, 95k miles for $3500. No rust, paint perfect, not a ding or scratch on the car. Leather interior, no fading, dash was perfect, no stains, no holes in the floor mats. It's an auto, but still turbo model. Original...

You don't have the 550s, nor the cash for them. Don't put the Lexus MAF on. The adjustable FPR is fine if you can tell what your A/F is, or even just set it to stock pressure. My recommendation, do the headgasket and valves, get it all put back together. Make sure it's running correctly, no...