Recent content by sethron71

Boost leak is not the same as a leak in the accordion hose. Boost leak would be post turbo in an IC coupler, IC, tb, or intake manifold. A leak in the accordion would still allow un-metered air to be sucked in but not metered air to be lost as there is always vacuum sucking on the accordion...

Missing tooth would only be used if you did not have crank sync. The cam is telling it when #1 is TDC. Very nice build! Seth

Hey Curtis trying to send you the throttle cable install procedure but your inbox is full. Send me a PM when you empty it and I will send the directions over.

Hey gats, I will post all the specs in a new thread shortly. As for the worry of rebuild parts I will have all the parts sourced and part numbers available before I sell the kits. As I mentioned this was just some teaser photos. Will post more in an official thread down the road. Thanks, Seth

How about $1150 shipped with each person purchasing pads of their own choosing to go with the kit. There are a lot of options so rather than sourcing pads to meet each persons needs everyone can just purchase the proper pads for their setup. Seth

What kind of price range do you guys think for 13.5" with 6 piston calipers? Yes I know free would be best but realistically? Seth

Hey Ron, If you read the first post. The brackets and centric ring are useless without the CNC calipers. But that is a mute point as due to the issues with getting the re-man calipers we are headed down this road: Just a little teaser!: Any interest?!! Seth

Hey guys, Photobucket has been gay lately and the iPhone app was F'ed but now good. Here are some pictures of the mod: Here you can see the part number piece and how short it is. So maybe there is another part number that is longer? But my fix should work fine! Hope this helps...

Hey guys got the parts. Only issue is this retaining plate is too short. 33485-30020 - Shaft Sleeve Retainer Plate Doesn't reach from the bolt to the shaft sleeve. As well even if it was longer the shaft sleeve would have been too far out because the o-ring was slightly exposed. So I...

Bring them to me! Nice build here! Seth

Jeff one last question, it goes in the back passenger side sensor spot correct? I am assuming it is the only one the cable will reach. Thanks, Seth

Hey Satan, Also want to thank you for your peer review write up. One thing I went around and around on was the starter. I will post all my diagrams and such once I get this thing back in. I have an Aristo Harness so most the diagrams at Supra.NL didn't match but after going through a ton of...

Hey Jeff, Ordering the parts now, total of $37 new!! You are the man!! Thanks, Seth

Great info, thank Jeff! Seth

Can that all be done from the outside? Also I don't have the MA70 Auto anymore....