Ok so I have an 87 na shell which I'm swapping to a jdm 89 turbo engine. When I got the motor I noticed they had cut the wiring harness right behind the alternator where it goes to the fuse block, check connection ignitor and the two wire fancy little ground box. Well it took lots of wiring...
Sorry, I should have explained a bit better. I actually figured out the ic piping figured out it was my mistake I misplaced the right coupler. As for the acordian hose, its about 1/4" too small on to fit the turbo because it is bigger than stock
Im new to the site, I have an 87 na which I blew up so ive decided to do a jdm swap with a 7m gte. I bought a t61 turbo intercooler and downpipe for it from cx racing and they decided to send me a ic hose fitting thst is too big to mount to the turbo outlet. Any suggestions for fabbing...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.