Recent content by EOS

I’ve got a question, and hopefully someone can help me with this. While working with the alternator I got a short off the main alternator stud. I know I should have disconnected the battery, but I was in a hurry and simply forgot. Now my tach, temp gauge, oil pressure , and (I’m assuming) boost...

I’ve loved photography ever since I was a little kid, and I’ve been a pro photographer since I was 16 (I just turned 35 this past Sunday). I switched from Pentax equipment to Canon EOS equipment back in 1993. Consequently, EOS has usually been my username on internet forums for Idunnohowmany...

If you’re interested in keeping your emblem, rubbing alcohol can generally remove permanent marker from smooth surfaces. I’d recommend 91 percent alcohol rather than the 70 percent stuff as it works considerably better for removing permanent marker. This is a little trick I picked up...

As others have said, it’s a possibility is that he had the engine at TDC on the exhaust stroke, not the intake. Another possibility would be that a wire going across the top of the engine to the CPS got broken. You could also try starting the car as someone pushes in on the CPS connector...

You’re entirely correct, and I went back and edited my first post to reflect this. I think the reason I phrased it that was because the ARP’s instruction sheet said “To ensure proper thread engagement and accurate torque readings, clean and re-tap ALL threads in the block...

I don’t mean to sound like a jerk to anyone, but I’d recommend ignoring the various torque figures quoted by others. I’ve used ARP head bolts or studs for virtually every car I’ve owned in the last fifteen years, and my personal experience has led me to four “personal rules” when using ARP head...

I get your point. Message received and understood: you know the removal of the EGR is a bad idea. And whether or not you decide to do this, you want to do anything you can to simplify the engine bay. I’ve seen this done on a number of different cars over the years, not just on Hondas. It all...

Somebody correct me if I’m wrong, but here’s what I know regarding the situation: solid core wire is generally used in an AC electrical system, whereas stranded wire is used in a DC electrical system. The reason for this isn’t because of additional flexibility with a stranded wire, but rather...

I’m with jdub on the issue of yanking the EGR: Pull it off with a stock ECU and you’re asking for a lean condition at part throttle (obviously a bad thing). When I was trying to track down the problems with the EGR setup on mine, I had Idunnohowmany friends from back in the days when I had my...

The turbo oil feed line uses a banjo bolt with two crush washers, while the oil drain back line uses a gasket. If the leak is coming from the turbo lines, the turbo will have to be removed so the crush washers and gasket can be properly replaced. I suppose you could try tightening the hardware...

Mine had a very similar problem. When I bought my Supra, I got it “for a song”, so to speak, because it had multiple wiring problems, the result of those wiring problems being that nobody seemed to want to buy it. Fortunately, I’m enough of a geek that I actually ENJOY fixing wiring problems...

While I like sleepers as much as anyone else, I've always thought the MK3 looked best with a wing, whether it's the 87-88 one piece wing, the 89+ three piece wing or an aftermarket whaletail. But please, for the love of Supras everywhere, don't put on a huge "ricer" wing... Ultimately...

If you're going to "go through" the wire's insulation to check for voltage, don't trim off some of the insulation with a knife. Instead, use a small straight pin or safety pin to pierce the insulation on the outside of the wire. This gets you down to the metal conductor in the wire, allowing you...

^ I'm already looking for a new place...I'm just trying to figure out the best place to safely park the Supra while I'm still living here. :3d_frown:

MODS: If you think this belongs in the Off Topic section, by all means, feel free to move it. My apologies for the excessively wordy post, but I’m hoping to get some opinions on what to do here… A while back, I posted a thread in the Off Topic section entitled “Why I park in the...