wire tucking project

[FernandoDLT]

On my ma70 1jz, by opening up. The harness iwas able to move the ignitor/dli and inj resistor into the dash without cutting wires. However the timing loop went too
But. My engine harness firewall hole is on the driverside now

I'm getting ready to paint my engine bay and have been thinking hiding my harness this way. How are you running the harness to be able to fit with all the AC components in there? I didn't spend too much time looking but it seems like it would be too tight in there?

 

[Scooter7M]

Were there ever anymore updates as far as your wire tuck?

 

[Supraguy7M]

I did end up finishing it. The passenger side was a pain. I ended up extending all of the wires on that side to tuck them up into the wheel well. I broke my old phone, so I'll have to find the pics if anyone is still interested or needs help with it.

 

[Scooter7M]

In for pics

Sent from my HTC One mini using Tapatalk

 

[Supraguy7M]

I'll see what I can dig up for pics. I posted a lot of the project to my Facebook so I might have them still.

 

[BabylonDown]

This is too funny. I was just searching for wire tucks to clean up the engine bay and this is EXACTLY what I am looking to do. It's too funny to see how this thread was last updated only 3 days ago. WEEEEE

I watched a video of someone installing some LED Headlights on a Supra with a GoPro on and always wished mods like this were filmed from beginning to end and stickied for all of eternity.

 

[FernandoDLT]

I did end up finishing it. The passenger side was a pain. I ended up extending all of the wires on that side to tuck them up into the wheel well. I broke my old phone, so I'll have to find the pics if anyone is still interested or needs help with it.

How did you run the wires? I ony had to extend 2 wires on the passenger side (AC). Other than those two, that side was cake. I do want pics of the drivers side. I'll tackle that side in a couple of weeks

 

[jessemkiiis]

took me a while but it turned out nice, going to go a little farther while Im doing a JZ swap.

Before

After

 

[Silver MK3]

^^Looks good, I like the use of the strut bar as the hood support, very innovative!

 

[BabylonDown]

took me a while but it turned out nice, going to go a little farther while Im doing a JZ swap.

Before

After

Did you have to extend any wires on anything and whereabouts did you tuck everything? Care to snap a pic?

 

[jessemkiiis]

I extended a couple wires for my maft translator but that was it. everything went in the fender wells. I have some during pictures but didn't take any once it was done. I also made brackets for the big pieces and ziptied the rest.

 

[Supraguy7M]

I haven't been able to find any other pics so far. I've got a few more memory cards to look thru. Hopefully I end up finding them

 

[BabylonDown]

I haven't been able to find any other pics so far. I've got a few more memory cards to look thru. Hopefully I end up finding them

Me too.

 

[hvyman]

You can mount any relays or resistors on the rear of the inner fender wells. If you have a/c the wires need to be extended around. Not too hard tho.

 

[BabylonDown]

You can mount any relays or resistors on the rear of the inner fender wells. If you have a/c the wires need to be extended around. Not too hard tho.

Why specifically the rear inner well?

 

[hvyman]

The rear of the front inner wells.