Megasquirt thread: Megasquirt and You

[hvyman]

No not all low imp injectors are peak and hold.

Check with fic and see if your are in fact peak and hold. If there not you will just need resistors.

 

[jdmfreak]

This is the diagram I used when wiring mine
This way it uses the stock efi fuze

 

[Jay C]

Thanks hvyman I'll check with them. I know they are 3.2 ohms and they were flow tested saturated with a resistor. I wonder what size resistor I will need. I'll also have to find one that doesn't get too hot (which can be an issue).

Jdmfreak thanks for the info I'll print it out for when I am ready.

 

[jdmfreak]

TerrenceLP is using a Acura resistor Pack or 2 you should pm him for more info

 

[hvyman]

You will need about an 11ohm resistor. Megasquirt like resistance values of about 12-16 ohm iirc.

Wiring a resistor pack is the same thing except its in a box you have to mount. Just put a resistor inline on the ground side of the wire and it will do the same thing.

 

[Jay C]

Just received my stuff from diyautotune. I will start doing the wiring in the next week or two. Oh and at least on the ms3 pro the cam wire is shielded jusr like the crank wire.