Search results

  1. flyjum

    5M stock ct26 13.3 at 108~

    Stock CT26 2.5 inch intercooler 3 inch downpipe 255 Federal RSR tires Microsquirt on E85 16~ degrees timing AFRs are mid 11s First pass I hooked and it went 13.3 at 105 with 10.8 psi of boost I upped boost on 2nd run and a clamp failed in 4th gear 3rd run it held but launch was...
  2. flyjum

    Microsquirt Guide mainly for NA-T

    This is for the people who are looking to turbo their NA engine. This will sort of be a how to or at least how I did it. I had a turbo setup with a RRFPR and it never really ran well at all so I changed just about everything. It is a pretty cheap setup in terms of cost but it is a full...
  3. flyjum

    New CT26 dyno 573lbs of torque

    Went to the dyno again with two-step-n Running Alberts 60-1 CT26 Car made 467whp and 573lbs of torque. Boost pressure is 23lbs dropping 20~ Turbo could run more boost but with the break up no real reason. Boost chart in post 6 http://www.youtube.com/watch?v=b_Hl1OFHdic
  4. flyjum

    9.5 psi stock ct26 dyno sheet

    So I went with two-step-n to xact dyno and he could only made 1 run needs to go back for tuning now. The inter cooler piping kept blowing off so he had to get the pipes rolled. 343 rwhp 360 tq Build thread here Stock ct26 with intercooler and 3'' elbow 9.5 psi stock wastegate Built...
  5. flyjum

    CT26 year differences or what? Pics inside.

    I have 2 ct26 turbos here from a different year supras. One has the wastgate feed closer then the other. Notice where the wastegate is drilled for pressure. Is there any difference on these besides this? Both say 42010 for the exhaust housing one (first pic) has a rubber shield on the wastegate...
  6. flyjum

    13.66 basically stock 87 turbo. 8.5 psi

    My friend ran his 7m supra at the track. Well it has exhaust (stock elbow) a fully built shortblock 2.75 inch pipe where the 3000 pipe goes. 8.5psi (stock waste gate) 245 tires. best time was 13.66 at 104 mph with 2.25 60' best mph was 107
  7. flyjum

    Fastest mk3 7mgte supra? 8.62

    http://www.youtube.com/watch?v=keHP7k31s5I&feature=player_profilepage I think so. I bet he can go faster to. Was not a very hard launch.
  8. flyjum

    Fried some steaks now time for oil change?

    http://www.getg.com/products/products.php?CategoryID=1&ProductID=1 Has anyone seen or used this beef tallow oil before? It has a SM rating yet is made from beef fat.
  9. flyjum

    Injectors not firing. HELP!!! After BHG job

    I replaced my head gasket, did all everything, hooked up wires grounds...we checked every ground, every fuse. the cold start injector fires and sputter starts then dies. so the injectors are not firing... We voltage tested the CHARGE fuse in the engine bay. This is the strange part...
  10. flyjum

    Wotm invitational drag race. OCT 11th

    Any one hear about this? Im going for sure any one else? Turned out to be ok but... Ryan did all he could to get BL and the others to run but the tech guy was a not havin it. Here is a post from ryan. Kean, SW, Chris, Justin, Stacey Barnett, and everyone else who was actually here knows how much...
  11. flyjum

    Getting psi and no codes but weirdly slow?

    The car is a 87 7mgte. R154 trans and stock everything. Well we just fixed it and runs good... kinda. Well when we drive it runs good till it hits boost and bogs and sputters and does not accelerate. Could a bad bov be the problem? WHen we rev in neutral it sounds fine( bov seems very loud for...
  12. flyjum

    Shaft play? Explain please. Wiring problem as well.

    I know what shaft play is but which way is worse... When your hold the fin if you can move up/down or in/out IE toward the back of the car toward the front. Which one tells if its blown. I have 2 turbos and one has in/out other is up/down. My freind just got a supra with 60k on new jdm engine...