Search results

anybody know why these wires would have connectors like this? It's an 87 7mgte auto harness, I got the harness used, just trying to figure out these wires

So I have a GTE engine I'm about to swap into my n/a supra, I'm just curious what type of power I can expect with my upgrades, I have a three inch thick intercooler and all hard piping, three inch downpipe and a 60-1 upgraded ct26 any close guesses on HP at stock boost?

I know the wideband sensors have a three wire setup. power, ground and signal, is it possible to connect the supra ecu to the signal wire? Will it get an accurate reading? tell me what you think.

I have a Q45 TB, i had a custom Y pipe built to so i could install the TB, when i did finally install it, it ran but leaned out ("fuel cut" for you turbo guys out there) , so i reinstalled the original TB, I now have a TRD fuel pressure regulator installed, do you guys think it will have enough...

I have an N/A automatic and i want to swap a R154 into the car, are the driveshafts the same length?? and does anybody have a clutch fork laying around for one of those tranys

what are the differences between turbo and non-turbo head gaskets?

I just replaced the head gasket on my car, and its doing all the same stuff again that it was doing before I changed the gaskets, It was fine for a month or so then it just started acting up again. I work at a repair shop and one of the guys said I might have over torqed the head...