Search results

Making the auto crossmember work I am pretty sure I am going to have to weld and redrill holes

Ok so I put in a w58 in place of my automatic I got the tranny mount on but it seems that the tranny is angle to the right is this normal oh yah this is on an 87 supra

I currently putting a w58 into an 87 supra my rear mount does not line up and I have a the drive shafts that came with the tranny but nothing lines up up or like I have been told it would any suggeations

It is your dowel pins in the center of the block there r two one on each end use a small pry bar wrapped in cloth it will pop up just do it gently right in the centet of the end of the head

I actually just got an 85 celica supra with the w58 in it I decided to just go with that I only paid 250 forthe whole car couldnt go wrong I dont think it will take much to swap that tranny inti the car

That is the other motor I was thinking about trying to see if it will fit on maybe we can swap notes if nobody else has any info

Is it possible to swap an r150 tranny into supra 2jzge

Where r u getting a metal head gasket for 140

I am running out of money for this project I am having every thing resirfaced but I cannot afford a metal gasket right now

I have to rebuild my motor just curious about graphite head gasket r they good or bad

I think I figued it out ran a compression check and it was very dissapointing

The two middle pegs in the clipp should each have each have twelve volts

I have checked the timing repeatedly but cant figure it out I have tried two differnt computers and still nothing no codes r present so I am pretty close to being stumped and fed up with this car please if you know any thing helpful tell me or this car may end up in a grave yard lol just...

Thanks guys that is what I thought just wasnt sure if it would mess anything up now the resistor wires I just hook them together right

I have an 87 toyoat supra 7mge I cant find a fuel pump relay can I build this relay and if so how

The wires that go into your diag plug are probably pushed thru the bottom of the plug the other thing is make sure your putting the wire jumper into the middle of the wire clips inside the diag plug

Will my isc valve cause my car to not start and smell like it is flooding