Search results

Does anyone know if an N/A Cat would be a bolt-in replacement for a stock turbo cat? Thanks.

Hey Guys, Just picked up a 92' Turbo targa Auto, as DD/Project car. It's not currently running, I towed it home. The car cranks and turns over no problem, but stalls out within 1 second of starting, even when given gas. The engine bay is not pretty at all, the prior owner did quite...

So basically, car was running normal (BPU 89' Turbo) I had been driving for about 10 minutes, the car was warm. I'm in 3rd, going about 40 MPH, when out of nowhere, the car loses all power. My tach and speedo drop to zero. All my electric Defi gauges freeze in place (EGT, Boost, FP, Oil...

Here is my fuel setup. - Walbro fuel pump - Aeromotive fuel pressure regulator - 550cc Bosch fuel injectors, Part # 0280150403 - SAFC II - Lex AFM Base fuel pressure (W/o Vac) = 40 PSI Vaccum draw at idle = 21 inHg AFR at idle = 18 +... Higher than my AEM Uego reads Minor misfire at...

* Pics in post 21 * I've got my timing belt off, lower timing cover etc. I've got a very small amount of freeplay when I have the pulley itself on the crank, the crank does not have free play, on when I put the pulley on. Again, this is without the timing belt on. The play is the...

Can someone take a clear picture of the throttle stop screw and lever for me? I'm adjusting my TPS, and want to make sure I'm measuring the right area with my thickness gauge. Thanks in advance.

So I've had my car off the road for 7 months, in that time I have replaced many things, and done a lot of work on it. Recently installed a new, bigger turbo as well. The car fires up fine, starts to idle around 800 RPM, then as it heats up, a minute or so later, the idle drops to 500 RPM, and...

I've got a fully rebuilt motor. Forged internals, balanced, many other mods... Yada yada yada... Currently approaching 3000 K on the new motor... (1850 Miles) It's got a stock Toyota oil pump, shimmed 5mm I'm running Castrol Syntec 10w30 My upgraded Ct26 started to smoke about 300 K...

I'm wiring up a on/off switch for my electric fan. Using 14g wiring, is a relay neccesary? I'm think no, but want to confirm. Thanks, - Kev

Just changed my oil today, switched over from dino to synthetic. Running 20w50 royal purple, very happy with it thus far. Raised my oil pressure about 40% After a bit of driving, I noticed a noise, a sort of grind, rattle coming in at the 2450 RPM range making noise till' about 2600 RPM. No...

Solved the prob. :D

Right now for general cruising my AFR's bounce between 15.4 - 17.9, is that too lean that its going to cause detonation at cruising. Or is this totally safe? My idle is sitting right at 14.7 - 15.3 Only running about 5 psi at about 20 - 30% throttle when I'm bouncing in the 15 - 18 range. Any...

Check this out guys. A girl I work with who is currently going through art school took intrest in my Supra and decided to paint it. I gave her a couple pictures to go off of and this is what she came up with. I just got it tonight, I couldn't be happier. I'm far from an art expert, but I...

Anyone have a Drivers side power window switch? Prefferably out of an 89? But 86 - 92 will do. Local pick up if possible. Let me know what you have ASAP! Thanks, - Kev

New parts - Toyota full gasket kit (Minus stock headgasket) - SOLD Topline OEM spec headgasket - SOLD OEM (Asin) Oil pump - SOLD New ARP Main studs - SOLD ARP rod bolts - SOLD Big AAron's manifold stud kit 7/16 (out of car) - SOLD Used parts - HKS FCD - SOLD 440...

I've looking into clutches deciding what will be best for my application. Will be putting 450 + at the rear wheels. I've heard tons of good things about the Spec stage 3, but very little about the stage 3+. Here is some info on the stage 3+ For heavily modified street and race engines...

CT26 with 175,000 K on it. Has some shaft play, good candidate for a rebuild - $150 obo Stock 440 CC injectors, good condition - $50 obo Turbo AFM w/ working electronics - $30 obo K&N air filter w/ stock airbox, good condition - $30 obo Brand new OEM specs headgasket - $75 obo...