Search results

i replaced my dash harness from my 90 supra turbo but now the ignition plugs dont match up to the dash harness...there are two extra plugs and the the main connector is different, i think the harness i got is a Canadian harness....any one has a dash harness diagram for the Canadian model....or...

i am curious to no if i do a mk3 2j swap, can i use the stock 2j gear box with a 1j bell housing....or do i just use the r154

i am wondering if it is possible to use a 2jzgte Manuel tranny fited with a 1jz bell housing will fit in a mk3 with a 2jz motor

just noticed that the oil pressure gauge is not working, i did a neg and pos test on the sender but no reading..any ideas?

i have ahd this issue for a month now...car starts but does not stay on, fuel pump works, i did the fp +b, 15 amp efi fuse gets power manin efi get and gives power....but fuel pump relay do sent get power,,,now when i open the air intake flap i hear the pump pumping but it does not prime so i...

dose any one have any fuel tank removal guides?

i have been trying to figure out for a min now why i am not getting power to my fuel pump....so i think that the pump is gone cause when i do the fp-+b the pump turns on but it dosent prime it sounds like its leaking so i think that it is not putting out enough pressure. so can some one tell me...

been having problems with my 90 7mge supra...no fuel so no start...i ran a ecu diagnostic test and got a code 22..so my question is if that runs back to the ecu will it stop the the car from starting?

wanted to know how i can bypass the control open relay in my 90 supra

i have a 1990 MK3, i need to find the relay location; circuit opening relay fuel pump control relay and any other relays that have to do with the fuel pump and efi fuse.. i am not getting fuel so i need to chk all these relays and i don't exactly know where they are. also does and...

car wasnt starting so i started to check the fuses in the hood, non of the amp fuses were burnt but they were nt getten any power, only the efi fuse was getting power, i dont know what to do from here, need help. i dont kowe how to check relays to see if there are getting power but what i have...

i just finished putting in a 24k jdm motor but when i start her, she starts and goes for a few sec then cuts off, so i think that my pump is gone, also when i try to rev her she cuts off. any ideas

Car starts on first turn but when u press the gas she cuts of. When u press ir slowly she revs up but still cuts off. When driven she dosent do she gos stals and cuts off..

Does any know how much gear oil does a stock manuel tranny hold. And can i full it up from the shifter knod insted of the fill holw and when do i stop if i do. Car is a 90 supra.

well i tried to pull codes off the ecu from my supra and i did but i made the amateur move and i forgot that that the wire was connected to the diagnostic out put and now it dosent crank.... so i don't know if i blew any fuses so what now....i suppose i have to chk fuses but it like 10 degrees...

dose any one know the hac sensor wires colors, coating..i have a code 35 and my dash to ecu to engine harness has been dead to head wired by a moran, so my supra dosent start i also have a code 22, 24, and 51 so i guess i need to clear all of these to see if she will start.

ok, so my supra was startinf b4. i had to crank it a couple of times but she turned over, but now it dosent, i checked, 1. she has fuel 2.she has spark 3.starter turns the problem is when i try to start her she trys to turn over because i hear the back fire but then she jerks and...

how can i go twin turbo on a 7mgte motor and will my factory setup hold the power.

have a 88 converted to turbo, motor runs greate and the turbo spools and everything, but when i get in and drive she dosent go, she just sputors. i think that my fuel pump is shot...any ideas

i would like to know what i wld need and have to do to transplate a 2j swap to a mk3, fuse panel, intercoler, fuel and oil pumps..ets and what year supra wld be the best to do so with, also the gear box.