I had the red wire get pulled out of the speed density harness and I can't find a diagram or photo that shows which spot in the plug it came out of. Can someone help?
As you can imagine living in Western Oregon the wipers get a little more work than in some other areas. I cant seem to find another front wiper assembly in good working order. I need the plastic piece that inserts into the linkage and attaches to the drive motor. Has anyone overcome this same...
I just rebuilt my 7mgte fired it up and it runs beautifully. I installed a new AEM digital boost gauge and noticed at idle I am pulling 22in Hg. That seems to me pretty high and I was wondering if the vacuum can be too high? Could this be a sign of any problems I might not know about?
the steering wheel end of the shaft. I don't know if its ever been apart but when I went to loosen it, it just spun. I had to use a claw hammer to put pressure on it while
I turned the bolt to remove it.
I changed the subframe and when i did the bolt that secures the upper sterring knuckle to the intermediate shaft stripped and will not come out. My question is... can I just drill the bolt out and replace it with a bolt, nut and washer? I seems to me this would be the fix but I wanted the...
I have an 89 supra and have been doing a complete restoration. I was wondering if anyone knows where I can have my steering wheel recovered and the butons relabeled?
At a stop and in drive, the trans will be in first gear but as soon as you start to pull away the trans goes into second. Also, the problem seems to be worse after the trans gets warmed up.
If I put the selector in low it stays in first until I shift to second and lift off the throttle. If I...
yes TEMS car.
they have had the valve body in and out several times. I'd hope they would have put the valve body and gasket in correctly.
Devon- do you have a built valve body available?
I have an 89 turbo maft pro, 60-1 turbo and all supporting mods. I had the auto transmission rebuilt and ever since it has been acting strangely. With the cable hooked up to the throttle linkage and adjusted properly the car shifts into 2nd immediatly. (the car starts out in the wrong gear)...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.