Recent content by slacker

still not welded as my weekend is over ... but heres where the "cage" is starting as previously mentioned .. supports made and now tacked into place and then bent the support struts .... not welded yet .. so just a rough mock up .

thanks ... I will have a peek ... biggest problem I have with this and believe you me , I have been looking ... most of the builds in the build area are like 50 pages long ... it would take thousands of hours to read all of the threads in the build area ... sorry , but I just don't have...

hay all ... as we know these engines are being used in MANY different vehicles .. I am building one myself . I'm building a 7mGte for my hot rod 2WD ... so I have been searching for hours and even days for pictures googles pictures are all blurry and cant see any detail not a good source...

hey .. thanks ... so , with the tranny out again , I needed to make a modification for the speedo cable . plasma cut out the section that was interfering , and used a piece of 2" tube to fit .. should work .

so a little time this weekend to get a little done ... I'm bracing the front shock towers and building the front "tube" section , so I needed to get my real engine in , which I still need to add some things to , so I can make sure all my clearances will work so out of it covered shrink...

so some pics ... trany in and drve shaft mock up some new wheels :) ... and doors off steering installed I'm now doing some tube work ... I'm starting with bracing the shock towers and a mount for the intercooler so will post that up when I get some progress done

so been a very long time ... but it's finally back in the shop

me too .. research .. up dates ?

I probabally will when I get to that point .. you should buy some of my fenders :)

havnt even touched it in months .. new staff and training is taking all my time sorry .. no updates at all .

so in the pile of parts to be trimmed , finally got the bumper/valance done today ! had to add a couple of clamps for mock up it's rough , but will give you an idea .

yeah its a 90's truck bumper and valance , molded at 1 piece . I need to mold it into the front end to build the 1piece front flip .. same one I had mounted on it years ago when I was driving it

got a new piece out today :) ready to start putting the flip front together .

so havent been able to do much on my own stuff lately , so It was nice today , when I found some time .. built a smoothie cowl and got it trimmed then I started on the flip front cut the fenders in 1/2 , so they would be easier to work with .. trimmed off the mount flanges ...

trimmed up some glass pieces today .. time to start on the flip front .