I have a 91 supra turbo with stock hd unit with cd player and factory amp located under passenger seat.
I want to put in an aftermarket amp to power my new speakers, but I don't want to cut the wires from the stereo unit to the amp. I can't find an accurate diagram of my amp connectors. I have...
I don't know yet if I did a good job or not. I am having these problems. Can the vsv cause this if it is hooked up backwards? there are 2 of those on the vacuum hard line below the intake manifold. A vacuum line goes into the back of the power steering pump that comes off the vacuum lines under...
I would post a picture but then I know I wouldn't get any help! I cleaned the power steering screen already and changed the ps fluid. I have doubled checked and rechecked all harnesses and vacuum hoses. All seem to be in order. All vacuum lines are new. I had a 21 code, but I cleaned the...
I looked through each post and could not find any solutions to my problems. I just replaced the HG, put everything back together and the car started fine, but idles rough at 700 rpms. seems to have a lope to it and seems to be running rich. also, i have noise coming from the steering pump when I...
I discovered the problem, it was the ECU water temperature sensor. I checked with an ohm meter and reading was not per spec.
see web page.
http://www.cygnusx1.net/Supra/Library/TSRM/MK3/manual.aspx?S=FI&P=113
the engine now idles down as the car warms up after just a few minutes.
thank...
the engine idles high to long upon cold start up (say 7min on a 85deg day)
i want it to to not high idle as long as it does. i don't think it should take that long, compared to all other cars i have.
need help on my 91 stock turbo supra. After driving for a while and i turn off the car, then start back up, the engine sometime misses out and wants to die, until i pump the throttle and rev the motor up to around 2000rpm and hold for round 5-10 sec's, if i let off the throttle at that point...
Thanks for the info. looks like I will get a rebuilt rack from auto zone for $180 and try to install myself. Anything important I need to know before I start the job?
Yes I read the post, I would like more of an explanation on why? Sorry I have an excuse, I am a woman trying to fix my car without spending alot of money.:aigo:
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.