well i tried to pull codes off the ecu from my supra and i did but i made the amateur move and i forgot that that the wire was connected to the diagnostic out put and now it dosent crank.... so i don't know if i blew any fuses so what now....i suppose i have to chk fuses but it like 10 degrees and i want to know exactly where to go to avoid frost bite...
starting issues after pulling codes from ecu
- Thread starter tsparks01
- Start date
Sure you jumped the correct diagnostic terminals? You can blow the EFI fuse if you don't...suggest you check it.
jdub;1225717 said:
efi fuse is ok but i wodering if i blew my ecu cause when i shut the door the light stays on and used the diagram on the input box...i think the fuses blew on the inner driver side area ill check them today and c whats going on...ill get back to u...