Siemens Deka fuel injectors leaking? and tuning with SAFC2

[gotsomegetsome]

is it possible for them to leak on the side where the little hole is? I got these from driftmotion and one seems to be leaking from there. I will be taking the rail off to see if a new o-ring will cure the problem but these are new to begin withhhh


Lastly, will the safc2 change a/f under 1000 rpms using the 1000 rpm selection? it doesnt seem to be working for me, but it was before I put the new injectors in so I dont know whats goin on with it

 

[gotsomegetsome]

bump?

 

[hvyman]

Top or bottom?
What seals are you using?
What are your mods?

 

[gotsomegetsome]

I am using the o rings that came with the package... they are green too ( i dont know why)

680cc injectors, walbro 255, aeromotive afpr, stainless feed/return lines...

 

[gotsomegetsome]

I am using the o rings that came with the package... they are green too ( i dont know why)

680cc injectors, walbro 255, aeromotive afpr, stainless feed/return lines...

 

[hvyman]

Where is it leaking top or bottom?
Is it a little o ring on the bottom?
What injectors did you have before?

 

[gotsomegetsome]

it appears to be leaking from the top, I havnt taken it apart yet to see if it is broken but they are brand spankin new. I had stock injectors prior

 

[whitemike]

Did you lube it up before you put the rail on? If you put the o-ring in dry, then rotated the injector, you could have torn the o-ring.

-Mike

 

[gotsomegetsome]

Darn, i didnt put lube on it, I thought you shouldnt put any on there because it would later mix with the gasoline and that is a no-no.....

What lube should I use? K-Y brand? haha just kidding
I have some standard 3in1 all purpose household oil in the garage that I pretty much use on everything if that would be okay..