Replacement coupler size?

[Wendigo]

Anyone know what I can use to replace the coupling from the 300 pipe to the Throttle body? Local Toy Dealer quoted me $50+ for the OEM one and....well.....screw that.

Also, what is the outer diameter of the stock turbo outlet? Thanks, the saga continues. Eric

 

[hottscennessey]

you'll prolly need a 2.75" silicone coupler for the TB, you can make a 2.5 work with A LOT of work. I think thats right..

I believe that the stock turbo inlet is 3" or 2.75" as well.

 

[BooST305]

i used this cheap little coupler from pepboys that cost 7 bucks.its a little long but works pretty well

 

[89Turbo]

sumthin like $15 for a vibrant 4-ply, red or blue one.....

 

[jdub]

you'll prolly need a 2.75" silicone coupler for the TB, you can make a 2.5 work with A LOT of work. I think thats right..

I believe that the stock turbo inlet is 3" or 2.75" as well.

Just measured the 3000 pipe and throttle body inlet...both are 2.75" as hottscennessey said. Get a 3-4 ply silicone and 2 T-Clamps...much better and you're still out for a lot less than $50!

 

[chriso]

I bought a rubber coupling from Orchard Supply for like $4, trimmed it to fit and 8000 miles later it's still pliable and intact.

 

[mkIIIman089]

www.hightempsilicone.com