Push release injector clips, do they fit?

[CyFi6]

Just bought a set of RC injectors that came with the push release style injector clips (rather than the snap in wire version) and it looks like it is going to be a tight fit on the 7m. I am just wondering if anyone has used this style of clip and does it fit between the rail and the head/valve covers? Heres a picture of what I'm talking about.

 

[supraguy@aol]

They fit without mod, except for injector #1 in my case.
I had to:

A: Remove the small bracket on the fuel rail, that's held in by one screw.
B: Slightly dremel about 1mm of aluminum from the fuel rail.

Both mods took about 2minutes.

Here is the entire thread that I had made:

http://www.supramania.com/forums/sh...evo-injectors-today&highlight=injectors+560cc

 

[Nick M]

Mine fit without issue. At the same time, if you are pulling injectors, the fuel rail should be off anyway. You press it back on with new o-rings and a little petroleum jelly.

 

[CyFi6]

Awesome thanks for the input.

I may have an extra regular wire injector clip sitting around, if so I will use that for the number 1 injector. If not I will either do what you did or rotate the injectors so the clips are underneath like someone else suggested in that thread.

The RC's came with brand new O rings and top/bottom grommets, so I am happy about that.