Please help quickly. Need official document giving stock head height.

[Rollus]

Hello all,

I'm in a lawsuit procedure with a shop having changed my BHG without having decked my head.

I need a paper (TSRM, Toyota Datasheet...) which tell the stock height.

I measured 116mm as per IJ information in the head gasket selection thread ..

Seen this question asked on many occasions, here's the HG's for dummies version

1) Stock HG = 1.37mm compressed

2) Stock head = 116mm deck to valve cover surface

3) Stock block = 198.5mm from deck to main bearing saddle

If 2 and 3 are less that amount needs to be added to 1 to retain the stock compression ratio and squish/quench.

When resurfacing the Block be sure to take the Timing Case along to have it done at the same time or your new HG will fail in miles.

Block measurement = 198.5mm/7.81"

The new shop is on hold due to this lack of information.

Please help

Regards,

Reynald

 

[mikejza70]

I'm sure someone on here knows.....

 

[IndigoMKII]

I'm sure someone on here knows.....

Your avatar freaks me out a little.

 

[SideWinderGX]

I know a bunch of official Toyota documents have been scanned and posted up before (not sure if on here or SF, I can't find the thread) that displays weights/lengths/displacements of almost everything related to the car. Almost sure it would be on there, if I can find it.

 

[Rollus]

I know a bunch of official Toyota documents have been scanned and posted up before (not sure if on here or SF, I can't find the thread) that displays weights/lengths/displacements of almost everything related to the car. Almost sure it would be on there, if I can find it.

Would be awesome, thanks