Yesterday was my birthday and I got an AEM UEGO wideband. So last night I mounted the gauge pod and i attempted to run the wires. Well the only place that i could maybe even get the wires threw was the hole for the engine harness. So I tryed to stick the wires threw the grommet(already cut for a red wire to go threw). Got inside the car but there was no way to reach it with out taking the glove box out. So I took the glove box out and the plastic shield behind the glove box out. So now I could see and touch the ECU and all the wires that ran towards the fire wall. All I really did was grab the harness were it started to run out of my site toward the firewall, i carefully pulled on it not hard at all, the harness didnt really come out at all besides the feel of breaking it loose for lack of a better term, I carefully pushed it back alittle bit. Put everything back together. This morning went to go to school and the car wouldnt start. It cranks, has fuel(FPR gauge said so when cranking). What could have happened? By the way i have an old school SAFC. I took off the a-pillar interior peice by the way if that makes any sense. And all the fuses under the hood and under the drivers side kick panel are all good.