How to obtain at most 300 Wheel Horse Power

Oct 11, 2005
3,819
21
38
Thousand Oaks, CA
If quietness and a stock looking dual tip is your objective then this is the exhaust to get. It is a straight through design so its as free flowing as any 75mm cat back. It is not as quiet as stock, you will notice it at 2500 rpm under load but not under light throttle cruising. The only downside is the steel construction.
 

Supra mn

New Member
Oct 10, 2012
84
0
0
Jacksonville/Nebraska
I don't have any experience with it, but I've heard of many members on here running the Tanabe Medallion exhaust. Stock looks, quiet exhaust but a nice tone when you get on it.
I'm sure the members actually running it can give their input.
 

emiliorescigno

Supramania Contributor
Sep 17, 2006
1,199
1
0
Woodbury, MN
Supra mn;2062660 said:
I don't have any experience with it, but I've heard of many members on here running the Tanabe Medallion exhaust. Stock looks, quiet exhaust but a nice tone when you get on it.
I'm sure the members actually running it can give their input.

I've run the Tanabe exhaust on all three of my Supras, and I absolutely love it. The sound is very low, smooth, and quiet. Sometimes, I actually wish it was a bit louder even.

I'd take the Tanabe over the HKS (I have driven a car with the HKS before as well). They're approximately the same volume, but the Tanabe is a little be cheaper, easier to find/buy, and made out of stainless steel as opposed to mild steel. I've used the same exhaust system since about 2009 and it's still in fantastic condition.
 

loc182

Member
Jul 3, 2013
255
4
18
Grove City, Ohio
So would you say that this is fine? I mean I would drive in the winter just because it's a daily driver in Georgia but hopefully it gets warmed up by just sitting there... Anyways, in your opinion, would you think this is a suitable exhaust? I personally don't like the loud sounds that most exhaust/mufflers emit when there is a high flow or 3". I'm looking for one that has the stock appearance, won't create that loud exhaust noise when you're just moving at 2-3k rpm at 30-45 mph lol.

I mean I'm open for other suggestions as well :)
This is a pretty old thread, but I had my LET-T16 ceramic coated and it has held up well in the winters now that I am back in Ohio where it gets cold. I don't drive in the snow that much though.