error code 32

CarlosPTR210

New Member
Apr 5, 2006
435
0
0
Calexico,CA
www.ptr.com.mx
I have a 32 error code.

Before error code, I have a 51 code. SO:

I made a rewire from the ECU to the TPS and AFM

After the rewire, Error 51 gone but have the 32.

I check the wire to verify any open circuit in E1 but is OK.

So then I try to find any short circuit between VS and VC, but I don’t know were is the VS wire!

I check the wire from the ecu (VC) to the TPS and AFM and both are OK.



So what can I do??




sm_photo_missing.jpg
 

CarlosPTR210

New Member
Apr 5, 2006
435
0
0
Calexico,CA
www.ptr.com.mx
jetjock;967701 said:
Your profile says you're turbo. If so me thinks you'd better look more closely at the cause of a 32...

When I run at wot, afer the 3k the car run rich a/f 10, Tomorrow I will try to adjust the fuel with the SAFMC, but I dont know if that problem is caused my the 32 error.

by the way, the IC piping dosen't have any air leak, I test it today.

any sugestion?
 

supraman74

I bought it SUPPED up
Apr 26, 2007
89
0
0
51
Iowa
Code 32 is:
Air Flow Meter Signal (7M-GE) OR
HAC Sensor Signal (7M-GTE)
You have the GTE correct?
 

jdub

Official SM Expert: Motor Oil, Lubricants & Fil
SM Expert
Feb 10, 2006
10,730
1
38
Valley of the Sun
On '87-'88 turbos the HAC sensor in on the rail where the glove box screws into...has a plug with 2 wires...its black and says HAC on it.

'89+ ECUs have it built in.
 

CarlosPTR210

New Member
Apr 5, 2006
435
0
0
Calexico,CA
www.ptr.com.mx
jdub;967987 said:
On '87-'88 turbos the HAC sensor in on the rail where the glove box screws into...has a plug with 2 wires...its black and says HAC on it.

'89+ ECUs have it built in.

WoW thanks,

I was using the 89+ manuals for reference, that's why I don’t find any information.

Thanks to all for your support and patience

Regards.