Emilian's 1988 Supra Build

[Emilian]

Make: Toyota
Year:1988
Model: Supra (MKIII)

Engine:
7M-GTE
Block - Bored (0.04), resurfaced (0.06), cleaned
Crankshaft - Turned (previous owner), polished
Eagle Rods
Probe Pistons
-.25MM Clevite bearings
7M Oil pump hose -8 AN

Interior:
Corbeau seats (Forza)
Corbeau mounting brackets

 

[closetnerd]

Play with HDR settings much?

 

[Emilian]

A little

 

[scotty]

Nice Supra. Never seen that interior shop before, will be interesting to see fitment and quality! Did you add mass backing? What color?

 

[Emilian]

I ordered it without the mass backing. It would have been an extra $55 charge. I will post some pictures when I receive it.

On another note, I've purchased a set of Eagle Rods & Probe Pistons. I should be getting these in the next couple days.

 

[Emilian]

A couple iPhone pictures of the rods, pistons and a couple re-painted trim pieces.

MORE PICTURES TO COME.

 

[TweeT91109]

A couple iPhone pictures of the rods, pistons and a couple re-painted trim pieces.

MORE PICTURES TO COME.

Clean and subtle...and step by step. I like that.

On a a side note- Does that big digital alarm clock have a shift light on it? lol

 

[Emilian]

Clean and subtle...and step by step. I like that.

On a a side note- Does that big digital alarm clock have a shift light on it? lol

LMAO! It just projects the time onto the ceiling

 

[Emilian]

It's time to update my build thread. As of January 2nd, 2011, the engine is out of the Supra.

Being busy with work for the past couple days, this is as much as I could do.

Still have a little more work to do, before I can have the block bored, decked, and cleaned.

 

[91blackeye]

This is nice man, keep it up. You did a bang up job on the repaint of the interior too by the way, good work!

 

[Smartparts]

Are those from Harborfreight? I'm about to do the same thing. Do you think I can fit the hoist and engine stand in the back of a a4?

 

[Emilian]

Yeah, the engine hoist and the load leveler are from Harbor Freight Tools. If you put the backseats down, I'm sure they will fit with no problem!

 

[Emilian]

Need some help. What exactly do you need to do to remove the ABS break system. I know a non-abs brake master cylinder needs to be bought, but what else?

 

[pagii]

a know from other cars there is a module within the engine bay. on the supra's i am not sure if it is a sensor or if its run to the hub. I know on my all trac the abs was geared on the hub....maybe someone else can chime in?

 

[Emilian]

Here are some progress pictures, I managed to snap today.

 

[msimsi10]

your project is my headache::shootme::::hang::anic:

 

[Emilian]

I'm sorry

 

[Supra28]

I like where this build is going, the car looks nice. This will be another thread I'll be following. Good stuff man!

 

[vIetDrIfTeR]

harbor freaking it???
[/COLOR]

 

[Bluechulappa]

I approve!