A340E to W58. I bought a clutch kit and it came with 1 big clip for the throwout bearing/fork. The TSRM shows two small clips holding them together and for the life of me I can't seem to figure out how this single clip holds them together.
Auto Manual Swap help
- Thread starter supra_kid101
- Start date
Davismj711
PA Mountain Supra
Are you certain your clutch kit was for an NA and not a Turbo ? It sounds to me like you got the R154 clutch kit. IMBW.
There are no CLIPS in a W58 clutch kit. ( I just bought one from Exedy) You are either confused as to the tranny you have or the clutch kit you bought. Which is it?
Well it is a W58. It came out of an 87 NA car. It had a clip on it beforehand (i watched my friend remove it). I actually work at Exedy (but my plant makes torque convertors :nono
It just got off the phone with advance and they confirmed it's for a 1989 Supra W58.
Last edited:
I will tell you from first hand experience that clip is a bitch. I had to bend it so it would hold onto the clutch fork. I don't remember if there was one or two but I remember it being a PITA.
Oh wait I do remember now. I ended up reusing the old clips and tossed the new one back in the box. I also ordered a Southbend clutch if that helps at all.
Oh wait I do remember now. I ended up reusing the old clips and tossed the new one back in the box. I also ordered a Southbend clutch if that helps at all.
^^^^^Oh that little rectangluar copper-ish fork clip? I thought he was referring to something related to the release bearing itself.