Anyone using the Bell Engineering FPR?

[viperkillertt]

I have a co worker talking about the Bell Engineering FPR. Does anyone have any thoughts on them? We might be putting it on my custom side project. Also, if they rock, i might grab one for my 1j. Has anyone here used one? I have only dealt with Aeromotive ones. Thanks!
http://www.bellengineering.net/product_info.php?cPath=7&products_id=4

 

[figgie]

Well

not to many ways to screw up an FPR unless the quality is of what comes out of a dog's butt.

That price is on par with what Weldon charges for their beast.

 

[viperkillertt]

not to many ways to screw up an FPR unless the quality is of what comes out of a dog's butt.

Wow, thanks for the amazing insight
Anyone else have any ideas?

 

[Turbo Drifter]

I have used one and use to sell them, there good for NA-T swaps on hondas and stuff as you can set it with a rising rate (4:1) and add that extra fuel under boost.

On a Supra I wiuld just get a Aeromotive and be done with it.

On a side note the Bell ones are ugly and quite big.

Jeremy

 

[viperkillertt]

I have used one and use to sell them, there good for NA-T swaps on hondas and stuff as you can set it with a rising rate (4:1) and add that extra fuel under boost.

On a Supra I wiuld just get a Aeromotive and be done with it.

On a side note the Bell ones are ugly and quite big.

Jeremy

Thanks! that helps. Yeah, the custom project is a d16 motor. But we are using a walbro fuel pump, so i don't see the point. And yes, it is very big and bulky.