30 amp

[lian]

ok so a month ago i finished a bhg job with the mk now my problem is that i kepp blowing a 30 amp fuse that controls the spark or fuel becouse the engine will turn over but wont fire.
i can always go buy a fuse a couple days later and get it fired up but when i test it down the road and give it some throttle or boost it blows the fuse again.

if any one has the slightest idea on were to start that would be great.

mainly the fuse blows when evrything heats up

 

[jdub]

We might have a better idea if we knew what fuse it was and in what junction box vs "a 30 amp fuse that controls the spark or fuel"...the fuses are labeled

I can pretty much assure you it's not because of the engine going into boost.

 

[lian]

sorry i was in a rush when i made the post, i lose all power to my maftpro when the fuse blows that should narrow it down.
i would tell you exacly what fusebut i have to drive 20 minutes to get to my car.

 

[jdub]

Sorry, but that doesn't narrow down squat...you could be powering your MAFT from any number of fuses. Guessing is a game that is very frustrating to play.

Since you can't take the time to be exact, we can't take the time to help. Good luck figuring it out.

Thread closed.