1JZ map sensor questions.

[JZA70 QC]

I need to know the pine out of a 1JZ-GTE map sensor as I'm going single this weekend with an AEM EMS V2 and I'll be using an AEM 3.5 bar map. I have the pin out of my AEM map but I can't find my stock 1JZ-GTE map pin outs and your help would be greatly appreciated. I found a picture of a 1JZ map here on a thread but didn't have the answer to my questions in the discussions.

What's the pink, green and orange wires? I know there's a signal (input), a signal ground and a 5 volts power, but I don't know which is which.

Any help will be greatly appreciated.

Thanks in advance.

 

[OneJArpus]

I believe if memory serves me correct

Ground (brown wire)
Signal (yellow/green wire)
+5V Reference (blue/red wire)

 

[JZA70 QC]

Is anyone absolutely sure of what the wires are as I don't want to wire it the wrong way and have electronic issues.

Again thanks allot for your help everyone.

 

[OneJArpus]

Is anyone absolutely sure of what the wires are as I don't want to wire it the wrong way and have electronic issues.

Again thanks allot for your help everyone.

i confirmed it this morning.


If you have any doubt take a multimeter and put it on the blue & red wire, but the car in the ON position engine off and it will read 5v