hey guys, im installing an AEM EMS on my 87 1jz supra. I'm making the harness and have everything pinned but dont know where the IGF goes (pin X17) Uploaded is the 1jz ecu pinout if each wire i used in black, and each i didnt in red. i also have all of the relays jumped except the efi relay.
When i hook up everything to my laptop i have gas cause i can smell it, and it shows that i have ~230rpm when cranking.
I dont know if anyone is familiar with the AEM computers on here. i have all of the wizards set to the 93-98 supra, 24 teeth (i can watch each tooth on the graph while it cranks) but i dont get an sputter, backfire or anything.
for the igt wires, i have them hooked batch fired like this: igt1/igt6, igt2/igt5, igt3/igt4 to batch fire them since i am using a aem for a honda and only has 5 coil outputs.
steven
also uploaded is my .cal file
When i hook up everything to my laptop i have gas cause i can smell it, and it shows that i have ~230rpm when cranking.
I dont know if anyone is familiar with the AEM computers on here. i have all of the wizards set to the 93-98 supra, 24 teeth (i can watch each tooth on the graph while it cranks) but i dont get an sputter, backfire or anything.
for the igt wires, i have them hooked batch fired like this: igt1/igt6, igt2/igt5, igt3/igt4 to batch fire them since i am using a aem for a honda and only has 5 coil outputs.
steven
also uploaded is my .cal file
