Search results

I bought this car back in September 2009. It was originally a black targa turbo auto with 130K miles. The car was completely stock with a bad 7M. I swapped in a 1JZ with an R154 a few months later. After three years I finally got the car completed. Current Picture Mods...

Hey guys I'm looking for a 1jz proefi base map that I can use to get my engine running after I complete my wiring. Thanks in advance My email is jadbir@yahoo.com

Yesterday I drove the car for the first time after the swap. The tranny shift up fine without problem but when gearing down it won't go in to gear. I bleeded the line 3 time. No matter what gear you try to go in it won't go back into gear unless you yank it.

My buddy is having trouble with his temp gauge after his 1jz swap from jzx90. He said that after 3 min the guage will go from cold to full hot within 20 sec but the engine is not over heating. He replace the sensor but the same thing happen. He disconnect the sensor and the gauge didn't read...

Had my car idling for about 40 min on thursdays, then yesterday I stated it up and the hydro fan blade won't spin ( not even by hand). How can I fix it? What cause it to go bad? Btw when I first got it I spin it by hand and after a couple revolution it would get stuck then I woukd have to...

Hey guys After my 1J swap the motor idle for about 5-10 min then shut off and won't start back. I'm getting no spark. I want to check my ignitor and jza70 ecu on your car or if anyone is nice enough to try theirs on mine. Thanks Advance

My 1J is not getting spark. After the swap the motor started right up and i only started it up two times for about 10 sec. Couple days after i got the Hydro, PS and Radiator all hook up. I started the motor and let it idle, after about 5-10 minutes the motor shut down and wont start. i found...

After the swap i started the motor it started right up with no problem. Yesterday i finally got the coolant, PS and Hydro setup so i can have the motor running. The motor was running for about 5 to 10 minutes and it just shut off. i try to stared it back but it wont start. The motor is...

Is this hole where DM oil pressure sender hose goes? i try to screw it in but it wont fit their

I have already extended my harness and now I have to wire everything up. I can't find the M1 11 pin connector that is behind the glove box also not on the 7m harness. The only connector that is behind the glove box is 1. IH1 2. IH2 3. Big gray 10 pin connector (is this one the m1...