I want to run a ford taurus E fan on my car, its commonly used because it pushes alot of air for a stock fan .
my question is if I take off the twin AC fans, and combine the two separate leads, could i use the combined power to power a the 16" fan?
does anyone know if it will turn on to...
Im currently in the process of getting this to run right.
engine is
stock 1jz(twins),
1jz harness.
New wires running to injectors(for sequential injection)
aristo auto ecu
AEM UEGO wideband
Map ECU2 running map eliminate mode <----this is my map sensor signal
r154
The engine...
Im looking at these injectors right now for installing into a 1jz. assuming I use a top feed fuel rail, will these fit without a resistor pack since they are high impedance?
http://tinyurl.com/dnxng2
Ok so i have a 1jz, walbro 255 and aeromotive fpr set at 38 psi with the vacuum hose off, stock turbos. UEGO wideband.
I installed my manual boost controller and set it for 14-15 psi, but i noticed it will sometimes stutter around the higher rpms. Im not running lean, my af ratios are always...
So Heres my 91 n/a supra with sport package
Its been lowered with H+R springs and KYB gr2s
I got the chinaman exhaust thats kinda stickin out a bit in the back until i can get a test pipe
I spray painted the front grill black..
Heres the motor thats soon to be swapped...
So I found A fan clutch and blade from a lexus ls400 at the junkyard.
Im gathering parts for a 1jz swap. The block already has the 2jz waterpump installed, The ls400 clutch bolt holes matches perfectly with the 2jz waterpump, however i dont have the pulley.
Can anyone confirm if the...
I was cleaning under my seats the other day and I found a bunch of loose cable under the rear seats, some of them led up to a type of electronic box behind the right passenger seat it had a motorolla logo on it
here are some pics
Also, My TEMS light on the dash doesnt light up since...
Ok so theres an engine set with r154 trans on ebay.
total cost including shipping would be around $2375.
Now locally theres a dude selling the 1jz motor+harness and turbos everything stock, FMIC .everything, Except the r154 tranny. he wants $900
so i know i will need a bellhousing id say...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.