Search results

Hey all, I got my car running after the cam sensor went out. First and foremost I broke one of the coolant sensors on the outside of the thermostat housing. Since I got the car running again its really hard to start when cold and usually requires to be cranked twice before it will idle. While...

Over a week ago I was timing the car and had the cover off the CPS and got a wire from the o2 sensor caught in there. The wire was fine, the EFI fuse blew replaced it and car ran fine. I drove it a few times shutting it off and starting it up a few times. I shut the car off in front of my house...

I've had a weird problem with my transmission since I've had the car. The transmission shifts find under normal accerlation. If I go WOT from a stop the car will not shift out of first. However as I found out last night if I take off normally until it shifts from first to second then put the...

I know I have a lot of these "where do these go" threads but everyone here is so helpful. I have the car all put back together after the rebuild, I was trying to start her up for the first time and couldn't get it to fire off. I remembered after the fact about some plugs I couldn't find the...

my transmission is empty with the exception of whats left in the torque converter. I have a bunch of quarts of Castrol Multi import vehicle ATF....can this be used or is it no good? I know the trans calls for dex II and I can use dex III or dex IV but I cant find any information on the stuff I...

Title says it all: I know the top line is for power steering valve but I can't figure out how its supposed to get there from the other side of the motor. The bottom one I'm pretty sure it goes into the back of the water outlet then gets a rubber line to the turbo....just wanted to make...

I accidentally bolted the head to the block not realizing that the lower rear timing cover had to be on there first. I tried to put the lower rear cover on and tapped it with a rubber mallet and slightly bent the MLS gasket. Question is can I safely unbolt the head without loosing the coating...

I took the white face gauges off my cluster, this white box was on the back and it looked like it was aftermarket, but it looks like it belongs there and I disconnected the wires. So where do the wires go and what is the purpose of the white box anyway?

I posted this in the 7M-GTE tech then realized there was an actual build thread section so here it is: Before I start the actual build I thought I would share a little about me. I'm 22, I work for the local county here in Georgia on the fleet vehicles(sheriff's dept. cars, vehicles for the...

Well I officially have a blown gasket. She keeps skipping bad on first start up then clears up and runs worse and worse as the temp rises. Used a gallon of coolant going to work and back and it didn't hit the ground and the intercooler wasn't wet. No heat out the vents and heat gauge fluctuates...

Hey guys, I just bought my supra a few weeks ago. It was hardly running due to someone swapping in a Lexus afm and not changing the injectors. I got that issue corrected and took it for a ride. the car runs just fine while moving and seems to miss slightly when my foot comes off the gas. It...