Search results

I used to run the Inifinity CS1 system waaay back in the day, and loved it. This has no bearing on your speakers, except to say that I like Inifinity's quality. My setup will be similar to Emerica's, but I haven't chosen front speakers yet. I purchased a set of Kevin M's front 6.5" speaker...

Actually, I like the way that wing fits your car; It looks like an early mkIII wing that is blended into the body line. I normally hate any form of wing that's been taken from another car, but that one kinda works.

I believe so, yes. If your wideband has narrowband emulation, you can substitute it temporarily(or permanently), provided you Wire resistors into the heater circuit. Cant remember what JJ said was needed, as far as the resistor specs.

Just a shot in the dark, but maybe a vac leak.

What part of the hatch floor? The spare tire well, or does the rust go into other parts as well?

I just picked up a fitted dashmat to go on my replacement dash. I think the fitted ones look fine, and you can always pull it off if you're 'showing' your car. But i will also look into a clear window film, since i have to replace my cracked windshield anyway. Also going to pick up the 303...

Does the 840ci have the same issues as the 850i? Because i luvs them German popups, too.

For what its worth, i think Probes are a great value in the piston market. People assign false 'max hp' numbers to the probes, yet they are made of the same forged alloy as many of the other high end pistons. Yes, the valve reliefs need to be addressed. But that is literally 15 minutes work with...

Way to go, man. So much love for the 80's monsters that embarrass the 'Justin Beibers' of the sports car world...(rsx's, sti's, rx8's...)

I'd heard that JZA70's were a good source for smaller CC's, but there's not alot of those in my junkyards...:) Hoping some early 90's USDM Toyotas came with similar sizes, though.

Finished wiring my PLX boxes, ran all sensor harnesses through the firewall. Ready to install new dash now.

I'm gonna go to the junkyard this week, and see what cars had smaller cannisters, that use a similar setup to the Supra. If I find anything useful, I'll post it for ya.

Went back into the garage tonight, and got a few more things done. I extended the boost solenoid, IAT and temp/oil pressure warning harnesses, and ran them through the firewall. Then I installed the turbo blanket. I may have to get a smaller charcoal cannister, though.

Wow. That's low.

I've read that 303 aerospace protectant is good for vinyl, unlike Armorall.

Um, no...With a car of that mileage, it is more valuable to leave it be. I would love to find a DD na/5spd in good condition.

Nobody's selling the entire setup. Morganson is selling the harness, and Nathaninwa is selling the mounting plates. It's up to you to get the coils.

I hope you're right, because I was planning to refresh my backup block, and it has Probe's in .020 over.

Thanks, PhxBlue...I hope so. Today, I did just a bit of coolant system work, installing the shroud, fan and aux fans. I wanted to fill it up with coolant, but I'm missing a couple of clamps for the hoses, so I'm waiting for those to arrive. Then I got busy with some electrical- wiring up both...