Search results

Looking nice.

Yes, the fork is held in by a spring clip. Should be mounted already inside the bellhousing.

All thats left of the old setup is the shortblock. I will sell it eventually.

Hmm. Been awhile. Haven't done much, because I was out of town for the past ten days. Today I finally put my old engine on the second engine stand, and ordered a few necessities, like coolant pipe gasket, ISCV seal/bushing, and chromoly flywheel and Spec 2+ clutch. The tranny work will be...

Progress is progress. :)

Looking very nice.

What type of paint did you use?

The hks doesn't include a turbo elbow. If you dont already have an aftermarket elbow, you'll need to either get one, or get a downpipe that has one built in.

Or, he may be parting out, and is just accepting the w58 setup to make the transaction happen, and will turn around and sell that stuff as well to get more $$.

Good. The can that i refer to IS pressurized. You spray it into one line, and crap runs out the other, into a waste container.

I know they make a tranny cooler flush in a can. Knocked alot of crap out of my Trooper's cooler.

I think its cylinder head supply.

Gee, you're absolutely right. You did say that. Sadly, i had misread what you wrote, and thought it was already in the groupbuy section. ...but it's not... ......hence, my sadness....When i get sad, my Alzheimer's acts up... Say- is this gonna be in the group buy section?

Ok, 18 posts later, you decide to mention that you have a completely custom clutch system that's been designed to work as a push-type?? lmao.

So, are you going to place a thread in the group buy section?

Yes i saw. Very nice. There's light at the end of your tunnel.

I would be interested.

What spacer? I wonder if you have the clutch disc possibly in backwards.

1/2 height.

did you take any pics prior to putting the head on?