Search results

How hard do you think it would be to put this......... into this...........

I'd say go for it but the shipping isnt worth it. He'll be ripping you off on the shipping.

No way, ive seen them rotors. Just one cardboard rotor goes for more than BBKs on the front and rear of the car. :biglaugh:

GASP!! You lol'd???? So did i. LOL!!!

Yea, thats a pretty cool pic location.

I read somewhere that there are differences between the clutch master cylinders for the N/A and turbo engines. Whats the differences?

Yea man, i looked at all 142 pages on the 7m technical discussions looking for information on swapping from N/A to 7M-GTE and how to build up a 7M-GTE. It's rough. But it's gotta be done. Look hard and look everywhere. Research and read. You'll learn quickly.

How does it get applied?

Ok well thats what i need. How much money was it to get all of that?

What is the purpose of the dynamat and how much you pay for it?

These girls are JDM tyte!!!!!:naughty:

Not sure if it's a bad idea or not but I like the idea of black valve covers with red stripes with the toyota in red as well. But thats just me. My entire car is gonna be black with red accents. So if you could, when you get this done please let me know how much it's going to cost. Thanks.

Interior or exterior........

Lol, o yea. Sorry robeats. Almost hijacked the thread.

Ahh yes, thats a sweet setup you got for the airbox. I'm thinkin about doing something like that....eventually. What did you use for the sides of the box?

^^^^^yes. ditto. i just did this earlier today lol

Whats the reservoir on the other side by the upper rad. hose for?

I'm assuming it's held on by a magnet like the XM radios do. Does the sharkfin antenna have to be on the outside of the car? If not, just put it in the hatch where the jack goes. In that little compartment. It's very thin metal right there so it might work. But i dont kno much about radiowaves...

Hot Dayam whered u get all the red hoses and lines?

Use a ratchet extension with a deep socket 8mm. Or use an open ended wrench to loosen and then unscrew with your hand. And by the way, you will need taillight gaskets. And it will take some tugging and pushing to get the lights out.