Search results

im getting code 52 which is my knock sensor code..the wire from the engine harness that goes to the clip that attaches to the sensor is completely broken off with no space what so ever topinch the wires back together..obviously i need to get a new connector to plug into the sensor but my...

ok so ive been overheating lately and my temperature gauge isnt working..ive replaced the thermostat, radiator cap, water temp sensor and about to change the water pump tomorrow..everything that ive done so far hasnt worked..as of right now my water pump is out of my car how do i know if its bad...

this may be long so please bare with me..ok ive been going at my car for 3 days now and no luck what so ever i may not be doing everything correct thats why i need help..ok first off the problem at hand i got my car back from the shop after they replaced my headgasket and put on a brand new...

my temperature gauge doesnt work at all i drove and it didnt work so i didnt know that i started overheating and now i dunno if im ok temperature wise after fixing everything because the gauge isnt working..whats wrong with it?..wiring?..bad?..old..what?..please help..thanks

i dunno whats going on all my vacuum lines are connected i dont see any hoses that are not connected and when i start up my car i sometimes get a little backfire..then close to the firewall intake side i have this load hissing noise that sounds like a really bad air leak..itll struggle to stay...

what do i torque the camshaft bolts to?

ok i just put on a brand new cylinder head and all new gaskets everywere possible on my engine..when i was finished putting in the camseals i was tightening down the cam gears to the supposed torque of 59ft/lb which i found online and one of the bolts snapped in half in the camshaft and the...

ok im just wondering just off the top of anyones head how much HP i should expect from my car..this is everything on my car that is not stock..3" HKS dragger exhaust, 3" testpipe. 3" HKS downpipe, HKS intake, Greddy TVVC MBC set at 8 psi for now i dont really know how much psi i should run, HKS...

ok i need help deciding what to do next after my BHG is repaired..and its getting repaired this week with a greddy grex 1.5mm HG and arp studs also with a brand new cylinder head and all parts along with it except cams..as of right now i have a HKS intake, greddy tvvc boost controller, turboxs...