Search results

Don't give out all the secrets just yet John.:icon_bigg

Here is a pic of a 6m next to a 7m. The 7m crank in the pics has been put on a diet. Here is more pics of the counter weights with material removed.

Congrats yourself too. No mini van untill the third kid. Two kids fit in most anycar, but by the time you have three kids you won't be affording a sports car anyhow!

Thanks everyone. Had to stay in the hospital for 3 days, but both my wife and the new baby came home today ( father's day). Perfect father's day gift. Had a few scary moments durning birth, his heart rate kept dropping down into the 60's BPM during a contraction. Doctor was half tempted to do an...

It has been a very stressfull month with going to the doctor with my wife every few days to check up on premature contractions. But with a bunch of luck and narrowly missing an emergancy c-section, we now have a new baby boy. He came one month early, but so did the other two kids I have. They...

Gary does not use any nitrous.

I am building the cyl head, crank, and block for the new set up. The new motor will shoot for well over 1500 hp and hope to be well into the 6's. Thanks for the props Gary!

Sean, Now you see why I used your car on my website Looking good!

Your cp pistons should have came with a build sheet that would list the dish cc's

I just donated to SM a good bit of cash again and I challange everyone with over 1000 post to do the same after reading this. Go with out beer and coffee for one week and pony up!

Hey John, Was really good to meet you too. I don't have too many forum members around me, so it is always nie to bump into someone. All I want to know is if anyone blew their hands up after the fireworks store?? Next time you come around we will have to fire up the grill and find the bottoms of...

My car has always been auto....

I mentioned making a set of oversized solid buckets in my last post.

For 800+ hp I would use a set of custom billet cams with a 9.5 to 10mm 235-240 duration@.050 lift for part time street use and a 10.5 to 11mm 240 duration@.050 lift if the motor is going to be drag only. Yes the ferrera springs will have enough clearance. I would make a set of oversized solid...

correct, but is usually better than factory spec since your machinist is only doing 6 rods and the factory did 10's of thosands.

I am in orlando now untill sunday morning and then will be driving back to ohio, Sean said he will be having a little Supra meet up after work down the road from Titan, So I will prob be there. Can't do too much more as I have the whole family with me. Would be nice to run into a few guys and...

Gerico seams to work pretty good behind the 7m with a 14" clutch

I am in orlando right now, may go over to Sean's little meet up on Wendsday near Titan. If you are around we can talk about the motor tricks.

The head should be hardness tested, then tested to check how much it is warped. If it is too far gone just get another head that is good. If your head it too warped, and you mill it flate on the gasket area, the top will still be warped. This will make for excessive "run out" on the cams. The...

I never said anyone had to spend 4k to do a swap. All I said was that a really good set up will cost a bit over 4K. Th400 built with a highflow pump to handle our rpm with a transbrake. Custom torque converter to handle the HP. Adaptor plate with a flex plate and hub adaptor GM front yoke...